The power went out this morning when it was on. now the light comes on and I hear the rely click but hot plate stays cool

the clicking your hearing is the relay trying to stay engaged, its heating up causing the relay to power down, which in turn you lose the lights, the heat is caused by the electrical current supplied to the replay, Not the outside temp , locate that relay and replace it, and your problem should be gone

hi :good morning i have a fisher receiver i set the timer off by mistake,now the stanby red light stay on and the receiver give no sound at all,what sould i do to set the timer back on ?

Check the thermestat,replace it dont cost much,also check your fan relay switch

1. is light on in side when you open the door. If not check breakers or fuses.
2. Can you hear the compressor running. If not do you hear any clicking sounds.
3. If you hear clicking sounds, try putting a fan on compressor and unplug refrigerator.
4. Wait one hour.
5. plug back in. If compressor starts let it run and see if it cools, if it doesnt, call service man.
6. If it goes back to clicking, call a service man.
please rate my answer.

There is a thermal cutout fuse located under the hot plate..these are designed to cut to power off if the plate gets too hot...the cutout will have some numbers on it and it looks like a metal cylinder with a lead coming out of either side of it...the numbers on the cutout are the temperature in degrees "c". you will need to make sure to replace it with one of the same type...Radio shack used to carry these, but I don't know if they still do...they are not very expensive though so fixing the unit would be an option...if radio shack doesn't have them anymore you could try the i-net or a local appliance parts store/repair shop..

When you heard the click and the compresor stops ,check if it's very hot , if yes the compresor is of on overload and this could happend because 1 the condenser coil is dirty ,2 the relay is bad or 3 the compresor has a problem .Also check if behind the kick plate there's a timer (some units have it there or next to the cold control ) that could cause a problem too.

you have a bad power supply....

Hi,

Many times a freezer and/or refrigeratordo not work right because of a dirty condenser coil...there are also many otherthings that can go wrong. If you are hearing a clicking or buzzing then check out thelast two tips.

If your refrigerator is running but warm, then...

Check out this tip that I wrote about that... it is a great place to starttrouble shooting your unit...and something that you can do rather then callinga repair person to do a simple thing for you...

Refrigerator Condenser Coil Cleaning Refrigerator Repair

Refrigerator Troubleshooting Refrigerator Compressor

Refrigerator Compressor Start Capacitor and Start Relay
Refrigerator or Freezer not Cooling or Getting Cold

heatman101

The 12 volts lights that illuminate the face plate are burnt inside and should be replace. It's a common failure on any face plate.

the "hot top" indicator lamp is switched by a contact on the plate cut-out. sometimes this cut-out is available as a separate part but often must fit complete plate. by plate i mean the bit that gets hot!