WSSH300 washer will not reset - General Electric WSSH300G Front Load Washer

sounds like you have a bad water valve or filler valve

replace timer

you probably need a new water pump

hold the start and select button in for about 30 seconds together until you hear a beep; this resets the control panel

Be sure to rule out one of the simplest things first---be sure the button that gets depressed when you close the lid is still functioning (or even THERE) Sometimes, if you have had a severly offset load, this switch can become damaged. Some washers will not continue to advance if it " thinks" the door is opened.

Try this, press the pause/cancel button twice. Open the door, ensure there is nothing blocking the door and close the door fully. Open the detergent drawer fully and re-close the drawer. Select Quick wash and press start.

If this does not correct the problem, call for service under warranty.

clarkco

Shut water off at faucet's pull out washer disconnect hoses from back of washer at water valve look in valve to see if it is clogged with sand , lime or anything if so clean out. put hose end from washer in bucket turn on faucet to see if you have water there then do same with other hose. if all ok remove water valve check coils with volt/ohm meter if bad replace valve if good check at wires that plug onto coils on water valvefor 110 volts with volt ohm meter if uncomfortable with doing any of this Call Repairman ..

I had that problem, try making sure your machine is level or it won't work