Who makes kenmore over the stove microwaves

It sounds like you may be experiencing an issue with your Kenmore stove's timer function. Here are a few steps you can try to resolve this issue:

Check the timer settings to make sure that the correct time and alarm settings have been entered.

Try resetting the timer by turning it off and back on again, or unplugging the stove and waiting a few minutes before plugging it back in.

Make sure that there are no buttons or knobs stuck on the stove, as this could cause the timer to activate repeatedly.

If these steps do not resolve the issue, it may be necessary to contact a professional appliance repair service for further assistance.

you will have to remove it. Not a big job. look online for instructions that came with unit.. Should be 2 screws thru bottom of kitchen cabinet

Just measure the inside dimensions of the unit in inches. Get the length, width and height then use this formula: (L x W x H)/12 = Cubic Feet

Hi,

Here is a tip that will help you to figure out what is wrong with your Microwave Oven....

Basic Microwave Oven Troubleshooting Tips

heatman101

One quick way would be to look on the top of the unit. Do you see empty screw holes where the screws going through the cabinet above it will go through and screw into the top of that unit? If no open screw holes on top of unit probably not an over the range model. Also, look under the bottom of the machine. do you see feet??? Or just aluminum screen vent filters. If feet and no filters probably a counter top unit.

you have done well out of the oven . it sounds that certain components are well worn and probably no able to get parts best advice it time to buy a new one

You may have shorting keypad or a problem on the control board.

FixYa's Web site is currently not notifying us when replies to our Clarification Requests are posted, so please reply back directly to me for free help and tips.

Please include your full model number and color.

A full Sears/Kenmore model number has 3 digits, a dot, then 8 more digits, such as ###.########

We're happy to help you with free advice and we'd appreciate your thoughtful rating of our answer.

William E. Miller
[email protected]
http://www.microwavedisplay.com

Hello, please use the chart to determine which stove you have. You will have to look at the model number. The first 3 numbers will be the series on the chart. In most cases an F1 error would require replacement of the electronic control. This part is commonly refered to as an EOC or ERC. However this type of repair is usually reserved for repair specialists.

KENMORE Range/Stove/Oven Fault Codes – 362 Series (General Electric)
F1 = Stuck Touch Pad Key - Replace Electronic Range Control (ERC).

KENMORE - 911 Series (General Electric/Roper)
F0-F1-FF = Failed transistor in Electronic Range Control (ERC).

KENMORE Range/Stove/Oven Fault Codes- 665 Series (Whirlpool)
F1-E0 EPROM Error - Electronic Range Control (ERC).
F1-E1 EPROM Error - Electronic Range Control (ERC).
F1-E2 U/L ERC Errors - Electronic Range Control (ERC).
F1-E3 Fuel Type Fail

Kill power 30 seconds-Cancel-Start/Enter-5 seconds-Should see “E” for electric-
“9” for gas-If code changes again-replace Electronic Range Control (ERC).

KENMORE - 790 Series Electronic Oven Control (Frigidaire)
F1 = Shorted Touch Pad = Electronic Range Control (EOC) Internal check sum error.
Runaway Temp = Replace Electronic Oven Control (EOC).

Kill power 30 seconds - if error returns - replace Electronic Oven Control (EOC).

Thanks

YOUR MAGNETRON IS MOST LIKELY BAD. THIS IS THE UNIT THAT CREATES THE MICROWAVES.

Hopefully the hood / vent fan was always on when boiling on the stove top.

Otherwise moisture can get into and damage the keypad or control circuit board.

That may be the problem.

If this is a convection model, it may have a bad thermistor (not to be confused with a thermostat).

The full model has three more digits, in case you need more help and want to post that.

If you or a friend decide to look into it, we have *critical* safety, disassembly, and troubleshooting info at our site, and our link is at our listing here on FixYa: http://tinyurl.com/yzjozk

You can usually find an exploded view by entering your full model number here: http://www3.sears.com (the 3 is correct)