Question about Harley Davidson FLTR Road Glide Motorcycles
...drops to 1,000 rpm's, then finally goes back up and levels off at 1,500 rpm's. Try this: Turn kill switch to ON/RUN position.Cycle the ignition(key) switch 4 times (each time long enough for ...
Question about Motorcycles
Can not set kill switch so that motor will operate> What information do you need to help? Most likely your kill SW when in run mood, you will have an open contact at your kill SW. When you are in kill
Question about Harley Davidson FLTR Road Glide Motorcycles
...piston and reeds. Starts and rund just fine till it warms up and it start to cut in and out and the kill swithch will not work. the funny thing is when the bike is cold the kill swith will work fine. ...
Question about Motorcycles
kill switch was turned off even keys off but ignition still cranking up on my vstar 650? The Kill switch only kills the ignition feed. Normally to the coil. You will find that the starter circuit ...
Question about Harley Davidson FLTR Road Glide Motorcycles
...changed the magneto flywheel spark plug but still no spark what could it be? Check the side stand kill switch. It kills the engine so that you don?t start out with the side stand down. If broken or ...
Question about Motorcycles
MY SKIDOO WAS RUNNING I HIT THE KILL SWITCH AND NOW IT WONT START AND HAS NO SPARK WHAT SHOULD I DO PULL CORD IS REAL TIGHT On most of the ones I've seen the kill switch just grounds out the spark, ...
Question about Harley Davidson FLTR Road Glide Motorcycles
Did I wire my Kill switch correctly on my '94 Yamaha YZ125? I purchased a kill switch for my sons YZ125. He didn't have one and he always had to dump the clutch to turn it off. The kill switch I ...
...and the rectifier module to go to the battery. I check all fuses. Thanks Check the side stand kill switch. It kills the engine so that you don?t start out with the side stand down. If broken or ...
Replace Kill Switch 1150 GS have opened hand control and removed retainer screw behind starter button, but still can't remove cover to get at the back of the starter button so as to install a new ...
...is it the wireing or the coil itself. should i get a new one? please help.. Check the side stand kill switch. It kills the engine so that you don?t start out with the side stand down. If broken or ...
46 questions posted
Usually answered in minutes!
15 Questions
14 Questions