Question about Stoves Kitchen Ranges
...issue. Test the oven control and timer: If the above steps do not resolve the issue, it may be necessary to test the oven control and timer. This should be done by a qualified technician with ...
Question about Kitchen Ranges
...Check the oven's control board: If the above steps do not resolve the issue, it could be a problem with the oven's control board. Consult a professional technician to diagnose and repair the
...issue Check oven temperature sensor, should be ~1100 ohms at room temperature. If too high or low, replace oven temperature sensor. the f1 issue is a stove runaway.. your oven got to hot and shut ...
...issue: Check the oven sensor: The oven sensor is responsible for measuring the temperature inside the oven and sending a signal to the control board to adjust the gas flow and heat as needed. If the ...
...issue with the oven display light and the oven light on the KitchenAid Stove KERS205TSS 2 may be related. The problem with the oven display light could be due to a faulty control board or a ...
Question about Kenmore Kitchen Ranges
issue. I have never known an oven with relays, or any device where relays are soldered. It is very odd. It sounds like your issue is a faulty thermostat. https://www.ifixit.com/Guide/Repairing+Kenmore
Oven stopped 5 to 10 minutes after pressing START I have some issues on my Whirlpool electric range. Model RF262LXST. The cooktop works fine but the oven stopped working 5 to 10 minutes after pressing
...issue you?ll have to check the oven temp. sensor circuit if the reading is more then 1100ohms then it should be replaced. Please do rate the solution if the issue is resolved or post a comment for ...
...issue you?ll have to check the oven temp. sensor circuit if the reading is more then 1100ohms then it should be replaced. Please do rate the solution if the issue is resolved or post a comment for ...
issue start by checking the oven temp. sensor for 1100 ohms, if the rating is more then that then check the control and door switch and replace the part that is bad. Hope this helps...please post back
24 questions posted
Usually answered in minutes!
71 Questions
56 Questions
54 Questions
38 Questions