...is at the faucet, the machine has no pump to increase the pressure, no washer does. there is a screw on the pressure switch but if you do adjust it only a tiny amount or it will go completely ...
...pressure, the shorter port screw is to adjust the cut off only, I don't know what the one with the red dot above it does. I don't know if the pump on tendency is adjusted for by turning the screw in ...
...pump_in_whirlpool_duet To access the Flowmeter and Pressure Switch - remove the three screws in the top panel along the back of the washer. With the screws removed, the panel should slide back, then, ...
pump is directly in the front under the wash tub. Check the area directly below the wash tub. If the leak is coming from the wash tub iteself, you may have a bad tub seal. A replacement gasket doesn't
pump is directly in the front under the wash tub. Check the area directly below the wash tub. If the leak is coming from the wash tub iteself, you may have a bad tub seal. A replacement gasket doesn't
Question about Supra Washing Machines
...screw clockwise back in until tight 5)Make sure to replace front cover tightly, there is a drip fuse that won't let the washer run unless front cover is back on. Socks are the most common I thing I ...
pump is directly in the front under the wash tub. Check the area directly below the wash tub. If the leak is coming from the wash tub iteself, you may have a bad tub seal. A replacement gasket doesn't
...screw. To recall an error code: Wake the machine by pressing any button Wait 5 seconds Press and hold the Start and Pause Cancel buttons simultaneously All LEDs will go blank and after a few seconds ...
...adjustment I can tighten up so the tub spins when shaft does? Thank you, Tom This assumes that you have a basic Kenmore / Whirlpool top load, direct drive, neutral drain (it doesn't spin until the ...
30 questions posted
Usually answered in minutes!
12 Questions
12 Questions