...Remove reverse light socket and re-seat bulb. Check for loose or broken prongs. Replace if necessary. Swap the reverse socket with the other side. the brake light has its own bulb. you have to remove ...
...remove the right bulb out and then use a test light and check if you have power at the socket in which you took the bulb out from, usuly the socket is bad or you may have a wire that is broken I have ...
...broken clips and replace as necessary. Now remove the two bolts that hold down each headlight at the top. Disconnect the wiring and bulbs and wiggle the old headlights out. Install the new ones and ...
Question about Cars & Trucks
remove a broken light buld that is stuck in the socket? How do I remove a broken light bulb that is stuck in the socket. I forgot if the switch is off or on? Use needle nose pliers Go inside the bulb
Question about Cars & Trucks
...not related to auto If you have a broken light bulb stuck in a fixture and the glass is shatterd, use a potatoe and press it into the broken bulb and socket. This will usually remove a broken ...
...remove each bulb, check if there's rust or corrosion in the bulb socket if so clean them, check wire for loose, open or broken wire ! Check if Ground is Good and if it has power on Parking and when ...
...broken wire to it also.check with a test light to confirm you have power to the bulb when brakes applied,this will take 2 people 1 to press brakes and1 to check for current with a test light at the ...
...Remove the rear light housings on the back of your GMC Yukon. There should be several light bulb sockets located on the back side of each housing. Grasp each of the sockets, and turn them ...
...broken wire on the headlamp harness or a bad headlamp socket. I would first remove the headlamp leaving it attached in the socket, with the lights on shake the harness and see if you can get the bulb ...
Question about Toyota Highlander
...good still does not work stop light was out so removed tail light and replaced bulb works now but signal light does not Check for voltage at the connection, could be a broken wire or a bad ...
625 questions posted
Usually answered in minutes!
375 Questions
318 Questions
275 Questions
235 Questions
204 Questions