2004 Toyota 4Runner "removing front rotore 04" Questions

Ad

Question about Toyota 4Runner

2 Answers

...front wheel assembly got them out but cannot get new ones in the wheel hub retainer wont come off any suggestions ? There should be access hole to install the studs without removing the hub & ...

Ad

Question about Toyota 4Runner

2 Answers

04 subaru impreza.frontend shimes at higher speeds when brakes are applied Front Rotors need to be turned or replaced. Good Luck!!! Your front rotors are warped. If they are thick enough they can be ...

Ad

...front or rear? Assuming rear, on the brake drum: Hub Removal If equipped, remove the brake drum (1126) ; refer to Section 206-02 . If equipped, remove the rear disc brake rotor (2C026) ; refer to ...

...front brakes on my 04 land rover discvoery, but not my rotors. Every time I stop it makes a grinding noise. something is not on right, remove the wheel that is noisy andc heck your work. While you ...

Question about Toyota 4Runner

1 Answer

...04). Lift the knuckle and hub assembly over the axle shaft and into the hub splines. Install the lower control arm on the lower ball joint. Connect the tie rod end to the knuckle. Connect the ...

04 durango. Feels like the pistons on my right front caliper are not applying enough pressure, but my vehicle is not pulling and I know the caliper is working to some extent because of the wear on the

...04 . Remove the front disc brake caliper bolts. torx bit. T20? Support the front disc brake caliper from the front strut and spring assembly using mechanics wire. Remove the front disc brake pads. ...

Question about Toyota 4Runner

1 Answer

...removing the front wheel spindle tie rod from the spindle arm with Tie Rod End Remover TOOL-3290-D or equivalent. Remove the cotter pin and castellated nut from the lower ball joint stud. Remove the ...

Question about Toyota 4Runner

1 Answer

...front caliber off the 04 expedition To remove the front caliper, you must pop pop off the anti rattle spring, pay close attention as to how it attaches so you can reinstall it, then pop off the hex ...

04 3500 4x4 that I am replacing the front wheelbearings on. I have the brake caliper and rotor removed, the four bolts that hold the hub assembly, and of course the nut and cotter pin from the spindle

Not finding what you are looking for?
2004 Toyota 4Runner Logo

431 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Toyota Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

ROBERT GARCIA
ROBERT GARCIA

Level 3 Expert

926 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...