Question about Toyota Camry
2004 jeep grand cherokee had oreilly's to clear the code and after driving about 100 miles my check engine light came back on now its coming back as the cam sensor again after having it checked Please
2004 Grand Pix starting running rough all of the sudden. I tuned it up and replaced the engnition module and it still running rough any suggestions? Electronic Engine Controls WARNING To avoid ...
...grand vitara (J20A) and error code P0340. What is it? p0340 is indicating a problem with the CMP sensor .. thats "camshaft position sensor" ... the 340 would indicate that the sensor is open or ...
...2004 Jeep grand Cherokee 4.7 HO The can sensor in most cases is located in the below mentioned position.The camshaft position sensor is located just above the oil filter on the right side (sitting in ...
...2004 Pontiac Grand AM SE, V6 engine? the cam sesnor is in the block at the very front of the engine, down below the power steering pump. the connector is near the oil filler cap, follow the wires to ...
2.2l. Where is the camshaft position sensor located? Did you try youtube?
Location of 2004 Grand Cherokee 4.7 Camshaft Position Sensor its on the bellhousing I believe drivers side at side of trans and engine.
Question about Toyota Camry
2004 Jeep Grand Cherokee (straight 6) kicks back into air intake! It does this while trying to start. It turns over well but just doesn't want to start. It had a couple times and once warmed up it ran
Camshaft Position Sensor Circuit FailurePossible Causes:CMP Sensor connector is damaged, open or it is shorted.CMP Sensor signal circuit is open or shorted to ground or to battery voltage or 5v supply
...camshaft sensor,crankshaft sensor,idle position sensor.Still did the same thing. Even went as far as changing the computer. The same thing happened. Put it in 2 mechanic shops on their ...
1,612 questions posted
Usually answered in minutes!
1,828 Questions
1,753 Questions
1,565 Questions
1,303 Questions
1,134 Questions