...FE and 3VZ-FE engines, align the jiggle valve with the stud bolt. Insert the thermostat into the housing. Fig. 1: Remove the thermostat housing from the engine with the coolant temperature sensor - ...
FE and 3VZ-FE engines, align the jiggle valve with the stud bolt. Insert the thermostat into the housing. Fig. Fig. 1: Remove the thermostat housing from the engine with the coolant temperature sensor
...FE and 3VZ-FE Engines Drain the engine coolant. Disconnect the lower radiator hose at the water inlet. Disconnect the timing belt from the water pump pulley. Remove the bolt holding the inlet pipe to ...
...3VZ-FE (and 2vz) this is your engine. and has many steps key is timing and proper belt tension and is free running engine. quote Prior to timing belt removal, make sure all the match-marks are ...
...3vz-fe motor due to blown head gaskets, the problem i have which i have never had before is every time i put the timing belt on i have to much slack on the water pump side of the timing belt and not ...
...3VZ-FE 1.5mm) Allen wrench through the hole to keep the push rod set. Install the dust boot and then install the tensioner. Tighten the bolts to 20 ft. lbs. (26 Nm). Don't forget to pull out the ...
FE, 3VZ-E and 3F-E engines.
This meter measures the amount of air flowing through the intake system. It is used by the ECM to calculate air/fuel mixture.
TESTING 22R-E, 1FZ-FE and 3VZ-E Engines
Question about Toyota Cars & Trucks
...FE & 3VZ-FE Engines Drain the engine coolant. Disconnect the lower radiator hose at the water inlet. Disconnect the timing belt from the water pump pulley. Remove the bolt holding the inlet pipe ...
750 questions posted
Usually answered in minutes!
1,828 Questions
1,753 Questions
1,565 Questions
1,303 Questions
1,134 Questions