1987 Honda Accord "high torque starter motor" Questions

...high compression engines and take a strong starter to turn the motor over. If you are putting key in and turnign to CRANK and you get no response, the power doesnt dim, and the lights dont dim when ...

high torque impact wrench or you need a special tool to hold the pulley. Make sure you get the timing belts markings correct before removing them. The balancer shaft belt can cause a lot of problem if

...torque high torque starter. Question edited for clarity. You can only go by the truck chassis. Anything to do with the motorhome has been done by the company that converted it. ...

...high torque starter their expencive but cheaper than buying 2 regular ones Some things to check: Bad ignition switch which causes the starter to not disengage after the motor starts. A short in the ...

high torque mini starter but that is now doing the same thing. Any suggestions?? Since you have replaced the starter motor with a higher torque one then the next approach that I would take would be to

...high torque starter or standard type you must be cranking the starter motor too much need to use it in short bursts only say 5 cranks then rest if the motor wont fire that kia needs a service and ...

...high as you can get it ( also make sure to chuck the wheels and set hte parking brake.) 2. disconnect the battery. 3. *under car" behind hte motor ther is the starter, it is connected to the motor ...

...high when I first start it up. What could be causing this. starter problem 2010 Toyota camry use hi torque starters will wind over faster . .if noise is very audible have starter checked over or ...

...high torque" GM starters may draw up to 250 amps, so refer to the OEM specifications to make sure the amp draw is within the acceptable range. If the starter does not spin freely, or draws an ...

...high current side of the starter is not working, this is likely due to a dirty or worn commutator or worn brushes in the starter motor. If you do see a larger drop in voltage( say down to under ...