1991 Honda Accord "coolant drain plug" Questions

...coolant drain plug:-- There's a hole in the underbody cover for access to the drain plug. Turn plug CCW to loosen until fluid starts to drain. Capacity is about 1.3 gallons of mixed coolant which ...

...Drain the coolant and knock out a freeze plug to install. Directions are included with the block heater, including usually which freeze plug to put the heater in, and the orientation of the heater in ...

...Drain about 1 gallon of coolant from radiator Follow upper radiator hose to engine should end at housing secured to engine by 2 or 3 bolts Remove housing make note how thermostat is installed in ...

...water clear or colored. If clear and ac was on it is condensation draining as supposed to if it is coolant then yes freeze plugs can be ...

...Drain, flush and refill with fresh coolant. You may chose to replace hoses first if in poor condition. Next - make sure all brakes are free and working, and that transmission works in all gears. Hope ...

...move the lever to full heat. It would be rusted from being parked. If that is OK, try draining the coolant, flushing the heater core by itself first with water, then blow it out with air. It is ...

coolant laek it is on the backside of the engine but i cant tell exactly where, it seem to be of the drivers side. im hoping its not the water pump A heater hose or possibly a soft plug. the soft plug

...drain fuel tank.fuel tank probably need to be removed and cleaned out to remove all sediment in bottom of fuel tank.remove each sparks and label them.squirt some clean engine oil down the spark holes ...

...Drain and Replace the Engine Coolant Fluid Flush Coolant System. Check and Replace PVC Valve. Replace Spark Plugs. Replace Ignition Wires. Check Distributor/Electronic Ignition Coil. Check Operation ...

...Drain the coolant onto a large drain pan and recycle the coolant === I just did a FREE write up on air purge from coolant system and how to detect initial state of blown head gasket at the Fixya tip ...