1996 Chrysler Town & Country "cam" Questions

code po340,change coil,cam sensor,still got code,missing that is the code for cam position. . when you replaces the sensor did you clean the cam,and replace the seal. what motor do you have

what could blow a new cam sensor Incorrect fitting??? When fitting a new cam sensor it is important to have the paper on the tip. This makes sure you fit it tight against the cam and then wears away ...

...no warning engine wont kickover 178,000. miles just had oil change 2 days ago check that the cam shaft is turning ( broken timing belt/chain) run fault codes to check for cam/crank position ...

where are the cam and crank shaft sensors located? The only code we got when scanned was cam crank shaft sensor intermittent. No check engine light is on. It starts but dies after 20 mins or so. the ...

I change the cam and crank sensor and the van stills bucks when drive it normal. Is this the starting point for your repair? Change the Cam? Or did you first do a good and compete tune up? This is the

...a round town still no good for about 1000 miles still no good I'm pretty sure this is an overhead cam engine. More than likely, the cam lobe is worn down ,or the rocker arm is worn down, or the ...

Cam sensor on 1996 Chrysler T&C Where is the cam sensor located anf how do you change it? ON THE TOP HAVE OFF ENGINE ,,

...pack,valve job,injector and placed on elec tester and all is preforming correctley. cam lift is correct. got any suggestions. FJ is your injector getting a signal. if so is your o2 ...

Hi, I have a 2001 Chrysler T&C. Check engine light is on for #2 & #5 misfires and cam sensor codes. Small emissions leak. This began after I had the transmission rebuilt. Replaced plugs, wires

...line up timing chain marks on 2002 town and country 3.8 eng. timing marks So I'm assuming it's twin cam so each cam has a mark on the sprockets line them up to a mark on the top of the valve covers ...