2002 Chrysler PT Cruiser "coil code" Questions

...code is for ignition ?oil A secondary sercuit No. Possible causes: Faulty spark plug or coil boot. Faulty ignition coil 1. Ignition coil 1 harness is open or shorted. Ignition coil 1 circuit poor ...

...code changes. If you have "Coil-On-Plug" ignition, you can swap the coil on #3 cylinder with the coil on #4 Cylinder and swap the #3 spark plug with the #2 spark plug. Then clear the codes and drive ...

...the spark plug wires and spark plugs and try again. If it still misfires then the problem will likely be the coil. lots could be the cause plugs, wires,coils,injection system need code to ...

...Please provide solution. Check on intake silicon gaskets, upper and lower. About $18 at autozone check the  #3 coil. code p0303 says misfire on #3 cylinder.this causes your vehicle rough

...CODE FOR # 1 CYLINDER IT COULD BE SPARK PLUG, STOPPED UP FUEL INJECTOR, COIL ( IF COIL ON PLUG TYPE ), OR PLUG WIRE . COULD ALSO BE A BASE ENGINE PROBLEM VALVE , BROKE PISTON RINGS, ETC. HOPE THIS ...

...Coil pack, or plug wire! P0304 code breaks down into “03” indicating an intermittent or no spark condition. “04” indicates cylinder #4. P02 conditions indicate a weak or split spark condition, ...

The car is running on 2 cylinder, No spark out from coil pack 1 & 4, 2 & 3 working ok. new coil pack fitted and cam sensor. If you have no spark on the coil pack for these cylinders, try scanning the ...

...coil. still getting code 1391. from 0 mph to 20 mph or at cruising speed the motor skips and revs up any ideas on why? The cam and crank sensors have the same power wire. Go after that one. They also ...

po302 changed plugs wires coil still codes If you changed the plugs, wires and coil pack I'd be checking the compression next. Also spray 2+2/gumcutter aroung the intake and check for a vacuum leak.

code P0351 Hi means ignition coil fault possibly replace spark plugs and wires possibly replace coil if needed if it's a DIY , do one plug and wire at a time so you won't lose order