2000 Chrysler Town & Country "right rear taillight fuse location" Questions

...Fuse Box, the fuse for the left hand tail lamp (viewed from the rear of the vehicle) is F64. The right hand tail lamp fuse is F63 - both are RED in colour and rated at 10 amps. Hope this

...rear Brake taillight needed a bulb replace in upper light so the screws were rusted and had to replace. I got them open and the lower bulb ok both right and left. I bought new taillights and replaced ...

...a wiring diagram here but I can't find the fuse for the brake lights or the right brake light sensor. The right brake light sensor is located in the trunk area by the right rear taillight

...right rear door8 20 Trailer9 - -10 30 Left-hand brake light; rear right turn signal; right taillight; right reversing light; high-mounted brake light;trailer lights11 - -12 - -13 - -14 - -15 15 Seat ...

...right turn signal light comes on on the dash and the actual front and rear lights. Any ideas? Open up the rear signal and check it for water, check it for corrosion, and or rust. it is must likely a ...

...right rear taillight same thing. Hello Sir It seem that you are facing some loose connection problems. Do check the following possibilities: Make sure that all the fuses and relays are properly ...

...Right what I would do is remove the rear light cluster or just unplug them and the front side lights and head light bulbs and Unplug the brake light switch now replace the fuse if it blows you have a ...

...Right rear turn signal on dashboard shows that it don't get power left rear turn signal just not blinking all bulbs are good no corrosion on battery or on bulbs Check the fuses. If not the fuses it ...

...right signal it works normal. I checked the wiring for current ahead of the connection on the rear where the trailer wire plugs into and the problem is towards the front end. Also both fuses in the ...

...rear holder, but if that does not work I am at the end of my rope. Any ideas? Where can I get the fuse diagram just in case? Where is the next connection for the wires if I just want to replace the ...