1999 Chevrolet Blazer "chevy rotor position" Questions

...chevy blazer how do i install the distributor? remove the distributor cap mark the position of the rotor on the distributor mark the position of the distributor on the intake or fire wall remove the ...

were is the camshaft positioning sencor located on a 96 chevy blazer 4x4 v-6 inside the distributor under rotor cap there are to screws that hold it in place.

...chevy blazer 4.3 vortec was running replaced radiator, camshaft position sensor, crank shaft sensor, rotor and cap, new plugs, checked plug and coil wires they are good firing order is correct, h at ...

chevy 305 vortec,stops after it rains,no fire,just installed new plugs,wires,cap and rotor,and crank position sensor,still no fire,and no codes it used to fire after a day or 2...then i replaced these

...Chevy S-10 Blazer, the distributor and rotor were removed without being marked. The book states that the rotor should be pointed at 6 and in time with the marks on the pulley. As far as I can see, ...

...chevy s-10 Remove cap. Remove number one spark plug. Turn key off...have friend manualy turn engine over until you feel air blow out of number one spark plug hole. when you feel this look at rotor in ...

Chevy blazer 4.3L vortec get bad gas mileage I'm only getting 225 miles to a full tank I would replace both o2 sensors and take the mass air flow sensor off and clean it with a non-chlroated brake

...chevy blazer Hello timrel: My name is Roger and I will help you. You will find the Camshaft position sensor located in the base of the distributor. Remove the distributor cap and rotor to gain access ...

Chevy Blazer, 4WD 4Dr, 4.3L. I changed intake manifold gasket today. When I pulled off the distributor, I didn't mark the position of the rotor, distributor and lower manifold. I thought a picture

rotor button point with the 1 piston up on the pressure stroike for correct timing on a 1985 s 10 chevy blazer with a 2.8L. V6 7 PM as you look toward the firewall & your over the dist The easiest