Answer
how many bolts and how do you get to the top bolts
Nationwide | 602-909-6450
1996 Chevrolet Blazer Repair, Maintenance & Service
Troubleshooting and Support
Click here to get instant support from our best Experts!
Solved Problems for All Chevrolet/Blazer
Questions and Unsolved Support Problems
Answer
where is the transfer module on a 1996 s-10 blazer
Answer
i have a short miss it will **** intermitante maybe every few secouds to 40 min. but seems lots...
(More)
Answer
1997 Blazer engine momentarily cuts-out at highway speeds, air bag light comes on, but keeps...
(More)
Answer
IT jumps like it is missing when it is running at high rpms until the tranny shifts then its fine...
(More)
Answer
i was leaving from a stop with my 96 blazer all the sudden i heard a noise like some disengaged had...
(More)
Answer
1995 S-10 All other lights/signals work perfectly. Upon garage test key in on position not...
(More)
Unsolved Problems for All Chevrolet/Blazer
Answer
2002 Blazer 4 dr, keep blowing the fuse for the interior lighting. Lighting includes sun visors and...
(More)
Answer
replaced ignition having hard time getting steering wheel to fit securely
Answer
i have a 1996 blazer and the power locks started went out and i checked the battery thats not it its...
(More)
Answer
i have a 1997 chevy blazer,we replaced transmission, and now it won't engage in 4 wheel drive. light...
(More)
Answer
1996 blazer code po701 tranny slips after warming up 45mph
Answer
need a snapshot of what the fuse box (with connected wires) for a 1970 Chevy Blazer. A blue wire...
(More)
1996 Chevrolet Blazer Manuals & Guides
Sorry. We do not have a manual for this product.
You can...
- Search for manuals of related products.
- Ask an Expert to find it!
Free Diagrams.
this is a tip for all those who are looking for free diagrams, free diagrams are very hard to get... allthough most of us have access to diagrams,...
written by jaysonemanme
2008 Highlander Maint Req'd reset proceedure
This is the reset proceedure for a 2008 Highlander with a key-type ignition: Turn the key ON, do not start the engine. Look at the odometer, and...
written by Toyota Ed
2005 thru 2007 Toyota Corolla "Harsh Shift" condition
There is a known issue with the 2005-2007 Corolla automatic transmission shift logic. The shift points may seem harsh, and the Check Engine light may...
written by Toyota Ed
clean headlight
take rubbing compond apply on front lends rub with rag untill compond is dry they look like new
written by pierre235
Dome light issues
There are two jam switches located on the latch assymbly. One on top and one at the bottom. They can become dirty and not function properly causing...
written by dlmcmasters
oil consumption
Believe it or not, it is normal for these engines to use about a quart every 2000 even when they are essentially new. Note that I said,...
written by chiquititas
reset change oil soon,low tire pressure.
I will explain this better! Turn off the radio and turn the key to the on position. Press and hold DISP knob, when info comes on window press the seek...
written by DAD5bbbbg
2008 jeep wrangler hood problem
I just bought a 2008 jeep wrangler and my hood is lifting 2 to 3 inches off the frame when I'm driving on the highway in wind speeds over 15 to 20...
written by newmdog
Upload Manuals
Find an Expert
Meet our 7229 Car Experts
Click here to get instant support from our best Experts!
#1:
tedpineywood
Rank: 
Guru
Guru
Expert
Rating:
89%, 619 votes
Solutions:
2092 (1119 Votes in the last 30 days)
Experience:
ASE Master Auto Technician since 1984
#2:
emissionwiz
Rank: Guru
Guru
Expert
Rating:
90%, 7809 votes
Solutions:
14047 (816 Votes in the last 30 days)
Experience:
40 years of automotive repair work, home appliance repair experience and general electrical repair.
#3:
johnjohn2
Rank: Guru
Guru
Expert
Rating:
91%, 277 votes
Solutions:
903 (613 Votes in the last 30 days)
Experience:
ASE CERTIFIED MASTER AUTO TECHNICIAN...
#4:
miket756
Rank: Guru
Guru
Expert
Rating:
85%, 166 votes
Solutions:
617 (617 Votes in the last 30 days)
Experience:
im jack of all trades but a master of none!
and being an old f*rt you get to learn a fair old bit
#5:
dmftrucker
Rank: Guru
Guru
Expert
Rating:
88%, 334 votes
Solutions:
1447 (519 Votes in the last 30 days)
Experience:
I run a Full-time Appliance Service Co.with HVAC/Auto Air Conditioning and Small Engine Service.
#6:
anguss693
Rank: Guru
Guru
Expert
Rating:
90%, 69 votes
Solutions:
420 (420 Votes in the last 30 days)
Experience:
qualified mechanic since 1986,trans rebuilder
#7:
wireguy212
Rank: Guru
Guru
Expert
Rating:
87%, 156 votes
Solutions:
567 (390 Votes in the last 30 days)
Experience:
been working on car and tractor electronics for 25 years.hydrolics is part of my john deere training.
#8:
bschilz
Rank: Guru
Guru
Expert
Rating:
88%, 459 votes
Solutions:
1104 (384 Votes in the last 30 days)
Experience:
I have owned a computer networking sales and service company.
#9:
jadamsrrfcu
Rank: Guru
Guru
Expert
Rating:
89%, 121 votes
Solutions:
383 (383 Votes in the last 30 days)
#10:
c17hydro
Rank: Guru
Guru
Expert
Rating:
91%, 959 votes
Solutions:
1712 (356 Votes in the last 30 days)
Experience:
21 years of automotive repair/restoration. Currently a hydraulics mechanic for C-17A cargo aircraft.
Find a Warranty
Specifications for 1996 Chevrolet Blazer
Key Features
Pricing
Recalls
Sponsored Links
Best Chevrolets
Recommended by Owners
Recommended by Owners
