1991 Chevrolet S-10 Blazer "replacing ingnition switch fuse" Questions

Ad

Question about Chevrolet Blazer

1 Answer

...gas in the intake. have checked all fuses, replaced coil, checked ingnition modual, and no codes. HELP!!!!! Dave TRY CHECKING THE KEY SWITCH. IT MAY BE DEFECTIVE. THANKS FOR USING FIX-YA. GOOD ...

Ad

Question about Chevrolet Blazer

2 Answers

...ingnition 3 feed to the VCM. It is one of the inputs used to determine the ignition lock/switch position. When this circuit is open the VCM sees the switch as always in the crank position, while in ...

Ad

Question about Chevrolet Blazer

1 Answer

...ingnition switch, alternator. There is a winding sound before it blows (was told its related to 4 wheel drive). Out of patience (&money). found one post that suggested the 4WD light indictor ...

...ingnition module still no fire what do I look for next? check the coil resistance ,also check coil wire, make sure that with key on that the posative side of the coil does have 12 volts. if power is ...

...ingnition. In order to start the vehicle you must put the ignition in run, open the hood, and use a jumper wire from the fuse box to the positive battery terminal to crank the car. Once the car is ...

Question about Chevrolet Blazer

1 Answer

ingnition switch to the fuse box, while performing this type of test, wiggle each wire and if you get a flutter in any one of them then it could mean that the ignition switch connection point for that

Question about Chevrolet Blazer

1 Answer

...ingnition switch,igniter/coil,distributer cap, rotor,spark plugs,checked all fuses,new battery, Try tracing the wires and looking for a worn spot in insulation that is grounding out, its a royal pain ...

...it'[s not. A it's not sending power to the coil and the fuel injectors when the switch is turned on. Where is the problem? is the ignition fuse popped or the ingnition control module ...

...ingnition switch, and fuses checked the timing car was running exellent before all this. i just dont know where to go from here? Hi, You will need to check the crank angle sensor which is on bell ...

Question about Chevrolet Blazer

1 Answer

ingnition switch or actuator In my 92 s10 blazer I put the key in the ignition and turn to the start position nothing happens. So I hot wire the starter with the key in the run position and the ...

Not finding what you are looking for?
1991 Chevrolet S-10 Blazer Logo

589 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Chevrolet Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...