...rear wheels,loosen front wheel nuts, jack up car, fit safety stands,remove wheel , remove grease cap from axle. remove split pin or locking nut on axle ,Remove hub, with a punch drive out the grease ...
Question about Nissan Sentra
...has 2 types of wheel bearings, cup and cone and a pressfitted one. I would like to know which one of the 2 would a Tata indica 2010 1.4 Lsi use Front bearing are pressed fit, the rear are pressed ...
Question about Nissan Sentra
...rear wheel but need to know what size socket is needed Hi Bobby,here's a repair guide how to replace,guides don't never tell you what size wrench or wrenches you will need,so you won't know till you ...
...rear wheel bearing on Tribute 2005..FWD Jack up the car and place on stands remove wheels ,remove pin and nut ,remove the brake caliper,slide hub off ,remove old cup,s with a hammer and pin punch and ...
Question about Mercury Cars & Trucks
...tire off, spin the drum if it spins more than 11/2 turns your rear brakes need to be adjusted or change, the drum should fit tight, hope this helps ya if not your wheel bearing are probably a gone,
Question about Nissan Sentra
...rear brake linings or shoes as they are also known as. I used the method someone mentioned here to remive the hub after I couldnt get it out. But the other side I battled then realised I had a huge ...
...rear wheel bearing. How difficult is this procedure. Hi Quite easy ! Slacken your wheel nuts, Jack up the car, support on an axle stand, remove the wheel. Knock off the little domed dust cap with a ...
Question about Nissan Sentra
...rear wheel bearing nut.Fiat Punto HGT Diesel 2004 plate I have fitted a Genuine rear wheel hub complete with bearings. The old bearing hub nut was not that tight coming off the stub shaft and was ...
Question about Peugeot Cars & Trucks
...bearing attached? Rear discs are supplied with new wheel bearings and ABS ring attached. Ready to fit them, need torque setting for the 36mm centre nut. Thanks. 170 foot pounds Ate recommends ...
rear wheel drive. 3 things it can be. propshaft donought bearing if fitted. 2 wheel bearing. 3, rear diff, been ran low on oil, the bearing has fried. if you go under the car see if you can wobble the
422 questions posted
Usually answered in minutes!
798 Questions
708 Questions
716 Questions
570 Questions
508 Questions