95 caprice classic starts runs good then the doors lock and it shuts off and you wait five min and it will do it all over again. ive checked all the fuses and replaced the alternator the fuel pump ...
...motor ran constantly, so I took out the fuse. Unfortunatly, that fuse also runs the power window, door locks and dome light. are those motors easy to change out? where can a person get instructions ...
Question about Chevrolet Caprice Classic
...Door Lock System Components The power door lock system consists of the following components: ?€¢ Body control module (BCM) ?€¢ Driver door lock switch ?€¢ Front passenger door lock switch ?€¢ Door ...
Question about Chevrolet Caprice Classic
...door lock cylinder switch • Front passenger door lock cylinder switch • Driver door lock switch • Front passenger door lock switch • Door lock actuators in each of the doors • DR LK Fuse 20-amp Door ...
Question about Chevrolet Caprice Classic
...door lock is pressed, lites flash,horn blows locks not. The trunk lock on dash will not work.Gas cap door latch on dash will not work. All locks work manualy with key. Power Door Lock Operation The ...
...door lock's are controlled by the BCM - body control module . Are you familiar with automotive electronic's ? Door Lock System Components The power door lock system consists of the following ...
Door lock receiver on a2001 Pontiac Grand am My doors locked when I put it in gear and unlock when I shut the key off but they don't work with the switch on both sides and the button that you push the
...door lock system includes the following components: • The door lock actuators • A door lock relay • An door unlock relay • A driver door unlock relay • The door lock and side window switches • The ...
Question about Chevrolet Caprice Classic
...door lock switches on the drivers door but the locks do not work nor does the back hatch or the switch at the back hatch that controls all the locks in the vehicle. Do the locks g Again there is a ...
Question about Ford Cars & Trucks
...Door Lock Function When a door lock control switch is moved into the lock position or a door lock cylinder is rotated to the lock position, a ground is provided to the lock circuit input to the ...
523 questions posted
Usually answered in minutes!
456 Questions
153 Questions