Maytag Neptune MAH5500B Front Load Washer "tighten belt" Questions

...tighten it too tight, do you think that is what is causing the motor to freeze up (or at least not pull the belt enough to spin pulley? pull the belt enough to spin pulley.use extension for you tools ...

...tub is tight on. Make sure the pully isnt loose. Inspect it for any small craks where that boltt tightens up. If the pully check out ok. Check the small motor pully as well. Make sure that isnt ...

...belt tight tighten the 1/2 in you should be fine Following is the Whirlpool / Maytag installation and service manual for the Neptune washer. Please see the section (8-1) on the drive belt and how to ...

belt by pulling firmly on the motor and tighten the bolts. Do not lever the motor to tension the belt as that could put unnecessary strain on the bearings of the drum and motor. Hopefully sorted! Good

How to replace and tighten belt on Maytag washer Model 310? Thx. hi there, please supply the full model # off your washer.

With a full load in the washer It squeaks when changing direction during wash cycle Printed a diagram of the way to tighten the drive belt and it worked. Thanks for the help

squilling sound while the washer is in the spin cycle most likly the drive belt needs tightened or replaced,if you need more help please contact me again.adrian,,,,,,,,,,

...and eventually "FL". Are there any recalls on MAH5500BBW? main belt needs replaced or tightened not going through the programs so electric/eletronic main power board thinks the machine ...

...by pulling the motor against the belt firmly- but not over tight- and the motor support bolts tightened. ON NO ACCOUNT SHOULD ANY FORM OF LEVERAGE BE USED TO TENSION THE BELT. THAT COULD LEAD

...together until the entire belt is fed onto the pulley. This will be very tight and not easy. Retighten the 1/2" bolt. Manually rotate the belt and pulley around a few times both ways (clockwise ...