Whirlpool Duet GHW9150P Front Load Washer "removing screen solenoid valve" Questions

solenoid. I'll attach a photo for reference. Sorry for your trouble and I hope this helped. Best wishes. u can 1st check your incoming water. turn water supply valve off behind washer. disconnect cold

...Solenoid Valve is bad....but it is possible. Sometimes the filter screen in the inlet(s) of the Hot & Cold water valve can be stopped up with dirt, sediments, etc. If you turn off the water ...

...removing the washer fill hoses; both the cold and the hot water hoses. Check for proper water pressure from the house. To do so, turn the water on and put the hose inside the washer or a bucket. If ...

...at the washer. On the washer side their should be a screen carefully pry it out and clean.#2 The mix valve solenoid for the cold water is bad .thats the valve that the hoses hook up to on the washer

SCREEN LF error means "Long Fill". Whirlpool uses a flow meter that detects the flow of water entering the washer. If this flow meter does not detect the correct amount of water entering the washer it

solenoid on the water inlet valve. Label the wires and connections so that you can properly reconnect them later. The wires are connected with slip-on connectors. Firmly pull the connectors off of the

...removing the washer fill hoses; both the cold and the hot water hoses. Check for proper water pressure from the house. To do so, turn the water on and put the hose inside the washer or a bucket. If ...

...removing the washer fill hoses; both the cold and the hot water hoses. Check for proper water pressure from the house. To do so, turn the water on and put the hose inside the washer or a bucket. If ...

...valve. Make sure they are clear or rust or debris. Check the solenoids for continuity using a multimeter or ohmmeter. A lack of continuity means a bad solenoid. I will attach a photo for reference. ...