Whirlpool Duet GHW9150P Front Load Washer "fabric softener tray" Questions

Fabric softener chamber is closed design! Impossible to work!!! I have to remove the entire tray from the machine, lift a part out to get the fabric softener where it can get into the system, every ...

...fabric softener run out when I put it in. I have to put it in when the machine is rinsing. It is one week old! We have the same problem. Sometimes it helps to bounce the fabric softener tray up and ...

fabric softener cup This is normal to have left over standing water in the softener dispenser cup. That being said, some units can have more standing water than others because the machine isn't level

fabric softener is leaking before it's supposed to in the cycle. If there is water left in the tray, the suction is not broken, and the fabric softener will immediately start leaking into the drum. To

fabric softener leaks out at beginning of wash My fabric softener leaks out at the start of the wash. I fill the dispenser to the max line and voila, it is out before it should. Why is this happening?

fabric softener won't despence take out detergent tray (you need to push small lever to get the try out) their inside tray one more part it says bleach & softner take that part too then wash tray

fabric softener does not completely was out of dispenser the correct amount of fabric softener was put into the dispenser and a load of wash was done, but about 1/2 of the softner was still in the ...

...fabric softener not dispense in my Whirlpool front load washing machine? If I recall there is a kind of latch or tongue on the bottom of the tray. You need to push it upward from the underside and it ...

...fabric softener don't dispense When the cycle is done, all of the bleach or softener is still in the tray. I understand that water will be added, but it doesn't look like that is happening. pull the ...

...fabric softener or liquid chlorine bleach) to dispense early: Check that the dispenser is not overfilled. Do not fill past the MAX fill lines on the dispenser. Overfilling can cause early dispensing ...