Hotpoint RGB745 Gas Kitchen Range "oven ignitor stays" Questions

oven Yes the ignitor stays on even after the burner is lit. The ignitor is wired in series with the oven valve. It sounds like the oven valve isn't opening all the way. A new ignitor should solve this

...Oven. Replaced ignitor. Amana AGDS902SS Gas Range Oven. Replaced ignitor. It Glowed until the temperature was reached and then the ignitor went off. Oven stayed lit. Problem: Ignitor burned out after ...

...oven ignitor switch..switch comes on, oven flames up, but is the ignitor suppose to stay red the whole time the oven is on or should it cut off after a few seconds? Given what you have said in the ...

OVEN WILL NOT STAY LIT HAVE A FRIDGADARE GAS RANGE THE OVEN SOMETIMES LIGHT SOME TIMES DOES NOT WHEN LIGHTE THE OVEN DOES NOT STAY ON sounds like you have faulty ignitors . replace the ignitors and ...

ignitor because most oven makers use this ignitor to mantain a warming temp (around 100 degree's) so since your display doesnt register over inital "start" temp of 75, i'd bet ingitor not coming on at

...oven ignitor is either out of adjustment or going bad. Turn off the gas. Open the oven and remove the lower oven cavity pan to access the ignitor. Set the oven to BAKE and watch the ignitor. If the ...

...oven ignitor and oven burner tube. install a Amperage meter on one of the oven ignitor wire, It should draw above 3 AMPS, if it is below then you have a bad oven ignitor, or just change the oven ...

oven wont stay hot while baking? Hi, The ignitor is not working right and is going bad.... have the repair man replace the ignitor, or DIY.... Check out this tip about your problem... Oven not Working

...Oven temp display stays at 100 Hi, The ignitor is not working right and is going bad.... have the repair man replace the ignitor, or DIY.... Check out this tip about your problem... Oven not Working ...

...oven is 100 degrees.The ignitor is located under the bottom inside the oven,Sometimes it will glow but it dont let enough power through to open the gas valve. I would say its an ignitor issue. Thank ...