Nordic Track Nordictrack C2050 Treadmill Motor Control Board For Model Number "starts incline" Questions

incline starts jumping up and down like it is slipping. It won't do anything else just keeps jumping. Put the key in and turn the incline to top setting (usually 10%) and as soon as the incline starts

E3 error on sole E95 elliptical Brand new machine giving e3 error. Ramp does not incline. The E95 incline motor is out of calibration. Recalibrate the incline by holding the UP INCLINE button and the ...

My console does not allow me to change the incline, speed, etc. The control panel does not acknowledge the buttons pushed. I've turned it off and on. my treadmill is doing the same thing. the only ...

I have an Epic t60. The incline stopped working. I was in the midst of going from flat incline to full and then back down again when it stopped. The incline numbers now register on the display, but it

started up my NordicTrack Incline trainer X3, it was doing the start up incline and then I heard a pop and smoke and another pop and smoke. Now its stuck in the incline position. Now the only thing ...

...starts then stops, the incline sensor may be defective. Be sure all the plugs are secure on the controller board. If the sensor is defective, you will need to order a new incline motor.. If the ...

I cannot get it to incline. It will say it goes from .5 to 10 and not incline at all First perform an incline calibration. The procedure is outlined in your users manual. It is a simple procedure. ...

Is there an online repair manual for the Golds Gym Advantage Treadmill? I'm trying to solve an incline problem. The incline does not go up when I push the incline button. I just get a series of beeps ...

incline not moving not calibrating Hi, Try to do the following hope it will solve the problem. if its doesn't solve the problem then the the incline motor or the control panel is faulty. HOW TO USE ...

...incline just starts all by itself, all the way up, sounds like it would keep going if it could, then it declines, its stuck in this loop. the belt never starts and I cannot stop the incline/decline ...