...power supply PCB is faulty. The DC controller PCB is faulty. Caution: To reset the error, execute the following in service mode: COPIER>FUNCTION>CLEAR>ERR. Action: 1. Connector Is the ...
...power supply or main motor board E202 Scan problem. Motor sensor E210 Lens drive problem E220 Exposure lamp E240 Main board or composite power supply E260 Main board, power supply cooling fan or ...
...power supply. While startup control is under way, the reading of the main thermistor is less than 70 deg C continuously for 200 msec or more 2 sec after the start of power supply. While startup ...
...power supply PCB is faulty. The DC controller PCB is faulty. Caution To reset the error, execute the following in service mode: COPIER>FUNCTION>CLEAR>ERR. Action 1. Connector Is the connector of the ...
...Power supply assembly, DC controller PCB 2) Replace the power supply assembly. Is the problem corrected? YES: End. NO: Replace the DC controller PCB. 3. E009 Fixing assembly 1) Is the fixing assembly ...
...for 5 seconds after the main power switch is turned on. Possible Cause: • Fusing thermostat defective or out of position • Fusing thermistor defective or out of position • Power supply board ...
Question about Ricoh Office Equipment & Supplies
...by the thermistor is below 71C and is not corrected after the main power switch is turned on. Causes: - Fusing thermistor defective or out of position - Power supply board defective - Loose ...
Question about Xerox Office Equipment & Supplies
power supply unit 2. If necessary, install a new power supply unit 2, PL 1.10 Item 4. 4. Switch off the machine. Remove the fuser assembly. Check that the thermistors, PL 10.25 Item 9 are clean and in
...power supply/ac drive board defective. Code 53 Fusing lamp overheat.Causes:thermistor short,power supply defective,main board defective. Code 55 Fusing thermistor open.Causes:thermistor open,main ...
409 questions posted
Usually answered in minutes!
1,105 Questions
603 Questions
557 Questions
354 Questions
183 Questions