OKI B4350 Laser Printer "replace drum check" Questions

...check image drum drum missing, i had paper jam took out drum to remove it then replaced it but keeps flashing this message Some drum units are "chipped" to prevent the rebuilding of of them and it's ...

...replace toner/drum though i already change new toner, i already check all the posible toner/drum sensor and clean, some boards also is new, the problem is still there.. hope you can help me with this ...

...check the unit, you must install the Printer Monitor software that came with the unit. Your problem most probably refers to empty toner or drum replacement. You probably need a new drum (not included ...

...printer and opening cover when paper picked from tray but before it enters fuser. if image good then problem caused by fuser and you will need to replace. If image bad then possible defect with

...drum unit is bad. It's the shiny brightly-colored large roller in the center of the machine. On most recent smaller machines like this on it's integrated into the toner cartridge. Check it out. If it ...

...the Oki Monitor Software Installed. So you can see what the real problem is. Perhaps you must replace the drum unit and make a reset on the Oki Monitor Software. If so you have your problem ...

replace on of the color cartridges.... From the OKI site, I found this information. My problem is a Flash 2 Blink, which is a problem with the cover or minor error, whatever that means. I can't figure

...drum. I actually needed to remove this strip by gently prying up one side to free it - when I retrieved the paper I couldn't believe that such a small and flimsy piece of paper could actually have ...

...drum assembly and set aside, remove the screw on the smaller back cover and set the cover aside (screw stays captive with the cover) then up near where the toner was there are two clips, one on each ...