Samsung SCX4623F Laser All-in-One Printer "codes error thermostat" Questions

...error code #02-000 on Samsung SCX4623F and how can I fix it? Dear Its related to the fuser assy. Pl. check the fuser thermostat and heating lamp. for if its open replace it, check the thermistor ...

...error The fusing temperature does not reach the standby temperature within 20 seconds after the main switch is turned on. ? Fusing thermistor defective or out of position ? Fusing lamp open ? Fusing ...

Ricoh 410 DN SC545 error code This is a code for fusion. Check: - Thermistor - Thermostat - Lamp Probably worth replacing the Fusing Unit, as the Thermistor,Thermostat,Lamp are part of the Fusing Unit

...error code of H4-01. Any suggestions? The fuser temperature is low. Use sim. 5-02 to check blinking of the heater lamp. if it blinks normally check the thermistor and the harness. If it not lighted ...

Error Code is C5. What fault is being reported? fuser MALFUNCTION PROBABLY A DIRTY THERMISTOR CAUSED FUSER TO OVERHEAT AND POPPED THERMOSTAT.THERMOSTAT IS PROBABLY STILL GOOD THERMISTOR AND HOT ROLLER

...ERROR CODE? C6000 is usually cause by fluctuation of current(power supply). STEP 1: Open top cover then turn ON the machine,press System Menu then scroll down to Service Setting,then HOLD BOTH the ...

...error....Really need a tech to fix this...could be bad wall voltage....or the thermostat in the IH unit...or the fuse in the IH unit...or the logic board.... e.studio 212 problems(error

...thermostat/thermistor that is not working, possibly a bad fan. You can cancel the error code (hopefully the error does not come back) by going into sim mode. press the following keys one after the ...

] [INTERUPT] [C] [INTERUPT] [14] [START]. If error still exists check the thermostat and heater lamp of the fusing unit. please where is the location of "thermostat and heater lamp of the fusing unit"

...thermostat. Defective PWB. -Replace the power source PWB or engine PWB and check for correct operation. After parts replacement (fusing unit), you need to clear the fuser error code by going in the ...