Kenmore 24 in. 15689 Built-in Dishwasher "remove lower cover driver" Questions

lower arm assembley is removable by twisting the center plastic piece. It's not very tight and should come off easily by twist with a pliers (but gently). Then remove the tubing to the upper arms (Two

...remove the lower arm and using a screw driver, remove the return cover. Clean out any obstruction and reassemble. If you are still having problems, your pump may be worn to the point it will not ...

...lower section must not be damaged all ,once the cover is off you will see a copper coil on one side and on the other a set of breaker points ,at the end of the points ,get a screw driver and push in ...

...lower arm is clogged and I don't know how to clean it. I can remove the filter, but it has several "windows" covered in mesh in which I can see debris, but I can't figure out how to open these ...

...remove the dishes and the bottom trey, In the very most lower corner of the inside of the dishwasher you will find a drain it will not look like the drain in you sink but more like a 2 1/2 inch ...

...remove the impeller from the motor. This is a kitchenaid dishwasher model # KUDS01DJBT0 Serial # FK3501342. you can acess the impeller, by removing the lower spray arm, ther are 5 torx scrws holding ...

...remove the lower spray arm (the little plastic nut in the middle of the arm can be removed with a 3/8" nut driver), then the dome housing, then the impeller, then the entire cover. This gets you down ...

remove the access panel. The upper panel houses the upper water heater element, and the lower panel houses the lower element. There is usually insulation between the panel door and the thermostat, set

...driver to turn the inside fan cover anti clockwise about 45 degrees which allows the fan module to be removed.  Then disconnected the drain pipe at the fan module only and power and control ...

...remove the lower spray arm and filter cover. These are torq screws. The accumulator assy. turns to the right to unlock and will lift off. It will take some pressue to snap it off the rear fill tube. ...