Question about Kenmore Washing Machines
Elite (Whirlpool) HE3 dryer is no longer producing heat. I've check to make sure the vent hose and it is not clogged. Can you advise if there is a circuit breaker, fuse or replacement required for the
...Elite 45986 Front Load dryer wont get hot ? Hi If the dryer is not drying the clothes then you would need to check for the following things- 1. Inspect the fuses and circuit breakers they may have ...
Question about Kenmore Washing Machines
...Elite Top Load wont start model 793.31552.610 All the lights are on and it starts after being unplugged all night. But will not start after. I replaced the door latch unit and that did not fix the ...
Question about Kenmore Washing Machines
...Elite Model 110.42926 202 after setting the desired cycle will not start when you push the start button The power is on to the washer. Door is closed. The lights will lit up when you select the cycle ...
...line or the fuse will pop again.and check the door switch,open the door,push the switch in and out if it makes a clicking sound most likely it's good.let me know what you find and send model
HE3 washer wont power up I have an HE3 washer that appears to be dead, no power. I checked power and it is good. Any suggestions? WON'T POWER UP. (Touch-pads do not respond when pressed) Check the ...
Question about Kenmore Washing Machines
...Elite Electric Dryer. Dryer only runs (drum turns and air flows) when pushing start button. Shuts off when start button is released. While holding this start button to run dryer no heat is produced. ...
line up notch at the top of filter with the groove inside and then slowly screw clockwise back in until tight 5)Make sure to replace front cover tightly, there is a drip fuse that won't let the washer
...elite calypso washer CE error massage Here is a link for the error codes on calypso, in most cases it is a blown fuse on the motor control board so I would first check that. Hope this is helpful and ...
...ELITE TOP LOAD Washer stops, won't fill, rinse or agitate ? Check the following: Is the power cord plugged into a grounded 3 prong outlet? Is the indicator on the Cycle Control knob properly lined up ...
1,909 questions posted
Usually answered in minutes!
3,839 Questions
3,158 Questions
2,098 Questions
1,023 Questions
908 Questions