...off. Thanks for your assistance. You may need to replace the drum rollers and front drum glides. The motor definitely is bad and should be replaced. A Maytag dryer is worth investing the repair
...with a little lubrication. I wrote about it and posted some photos Here My 4 yr. old Maytag quit in the middle of drying a load of towels. My problem was the fuse blew.Cost me $70 to have it
cost of the motor is $193.00. I’d like to avoid this expense if possible. The dryer starts making the noise only after the dryer is heated up. Wouldn’t the motor start making the noise right away, not
...that hold it to the frame and lift it of. Replace the parts. All are mounted on the front. Clean out the lint in the filter housing. The bearing and slides cost around 25 bucks total. This is
Question about Maytag Dryers
...bearings and most likely are worn out....They can be easily replaced by an average joe.... They cost about $15...Good ...
...replace (the easiest thing of the entire process). I suggest replacing both bearings at the same time - the cost isn't much, but the hassle of going back a second time isn't worth it (I found out the ...
...bearing/ housing the same thing, gone bad, This machine is old enough I would expect to find a worn housing or shaft, either drum or motor,most likely drum, check the alignment of the belt also, but ...
...replace the motor??? thanks - Diana try spraying wd 40 on the motor ends to see if it will stop if not try the rollers normally they go bad and make the belt squeel. are you saying that the motor ...
...a couple of hours of time if you do it yourself and if you have it done it will be 1/3 to 1/2 the cost of a new
...replace the thermal fuse --which is located below the heating element when you take it out. I have found that the thermal fuse kit (part #La-1053) works very nicely for this as you actually get two ...
1,555 questions posted
Usually answered in minutes!
1,410 Questions
750 Questions
524 Questions
182 Questions
177 Questions