At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
hi Bernard all mobility scooters are fitted with anti tip wheels however many people have them removed because of issues going down kerbs etc, they can stop the back wheels from gripping allowing them to spin in certain situations where you are steeping down from pavement to road etc...
Most scooter to take the wheels off is just a nut in the middle of the wheel with either a 17mm or 19mm socket. Leave the scooter on the ground and undo in an anti-clockwise direction. Some may have a tab washer which you will need to knock back flush in order to rotate the nut. Once nut is removed, jack up scooter on a block of wood so the wheel is off the ground and pull wheel off shaft.
WD-40 may need to be used and worked in between wheel and shaft on an old scooter as they tend to seize on.
There should be a guard over the wheel, held by several screws. Remove this. The nut holding the wheels loosen in the same direction the wheels turn so this would be anti-clockwise for the right hand wheel and clockwise for the left wheel. When replacing the wheel, ensure you replace the cardboard or rubber washers on the wheel. These spread the pressure evenly when the nut is tightened.
Most stoves of this type have both wheels and screw adjusted levellers (generally in the front only).
The lower drawer opens to reveal these in the corners or a loose clip-on front panel needs to be removed by gentle pulling. The knurled wheel like knobs are generally turned anti-clockwise (Right to Left as you face the stove) to screw out and thereby lift the stove front up to suit your requirements. Good Luck.
remove x2 T30 screws from the wheel arch liner and pull it back giving you acsess to the rear of the lamp. Simply disconnect the connector and turn the bulb anti clockwise to remove.
Firstly remove undertray from front bumper approx 15-20 screws 2 of which are screwed into either side of the inner wheel arch near the bottom, you should then be able to see the back of the fog lamp. On the back of the fog lamp you will see a black circular shaped peice of plastic, turn this anti clockwise then remove, you will then see a metal clip holding the bulb in place this unclips from one side and you can then remove the bulb and replace with a new one.
×