Changed tires with alignment yesterday also oil change - how do I reset maintenance lights and info

The TPMS lamp should go out when the proper air pressure in all tires is detected. Too much pressure will cause it to light also. The low threshold is somewhere in the 24-27lb range, dunno what the upper limit is, but one member at R4W had 44lbs, IIRC, and the lamp wouldn't go out until he dropped it back down. Some members run 38lbs and get away with it, but I run the recommended 32lbs and don't have any problems. Out of spec tire pressure does not cause the maintenance required lamp or the MIL to light up, see page 161 of the owner's manual. The maintenance required lamp will light up every 5000 miles as a reminder to change the engine oil, see page 136 of the manual for reset instructions.

To reset "Maintenance Notice" on the display, turn the ignition key to ON, with engine off. Select the "Maintenance Schedule' key by using the button to right or left. Using the button select the "Reset" key and push the "Enter" button.

i would go to nearest parts store and ask them to do an obd2 scan. oreillys, advance auto, and auto zone i know do it for free.

Hello. Welcome to FIxYa. Please allow us to assist you

The maintenance required light is there to remind you that your oil change is due. This light needs to be reset after the oil ic changed, it is manually reset. If you just had your oil changed, the light will not go off by itself. The light is designed to illuminate after 5,000 miles since the last reset procedure.

is it possible they did not reset change oil light?

The maintenance light needs to be reset manually. See my Tips and Tricks on this website for additional information on how to reset it.

You should also check your spare tire for proper inflation. It will set the tire pressure light, as the spare is monitored also. If all 5 tires are OK, you may have a malfunctioning tire pressure sensor. If the tires have been changed recently, people with older tire machines have been known to break the sensors regularly, by mistake.

If I remember correctly, on the dash you have a select button. Hold the button down then turn the key on, until the maintenance light blinks and goes out. Turn the key off then back on and your light should be out.

If you are getting an Maintenance Oil light then that is a reminder to have your oil changed...You will need to reset the mainteince light.
To reset "Maint. Notice" on the display, turn the ignition key on (do not start)...with engine off. select the "Maintenance Schedule' key by using the button to right or left. Using the button select the "Reset" key and push the "Enter" button. This should be outlined in your in owners manual as well. The oil pressure or low oil light looks like a little genie oil lamp. The Maint. Tire is the same concept, it's a reminder to check your tires pressure or do a rotation on them.
I hope this helps.

Here's how to do it

This is what helps the tech inspect your car. B Means to replace oil and oil filter. And inspect certain things on the vehical.

Sub systems
# 1 Means rotate tires and check tire pressure.
#5 Means Replace Coolant

What do you mean 15. Their is no 15 in the Maintenance Minder System.

To reset the Maintenance Minder System (your oil life) Make sure the oil life is displayed
#1 Press and hold the reset button for 10 seconds until the oil life flashes
#2 Press and hold the reset button for a additional 5 seconds.