I want to replace the handle bar on my 2007 Honda CRF100. Where is a good place to buy the part and how do I rempve the grips?

They now make a replacement tab so you don't have to replace the entire handle grip. The bad part is, most of the time it's the handle grip that has the broken place in the plastic, not the latch tab. That too can be bought seperately though, so you don't have to buy the hose. Call your local vac shop for assistance.

If you bought it used, you probably weren't told someone had installed a heated grip. There are two types: One is the actual grip with a heating element and the other is a thin heating element that tapes onto the handle bar and the grip is slip back over it. Look to see if either on are present on your ATV. If so you may have a thermostat or HI-LO switch to lower the heat.

Get a longer bolt the same thread size, screw it in and pull bolt out with grips

Need to be more specific. If it's removing the grip from the bar then I've found that using air works the best. Take your air nozzle on a compressor and put it on the back side of the grip and it will inflate it enough for u to work it off the bar.

assuming you have bought yourself a pair of rubber grips, with a sharp knife cut through the grip to remove it clean away any old glue, replenish glue onto grip and handle bar and simply push back on to handle bar quickly clean away any unwanted glue, remember to check you new grips for internal diamiter these will be different sizes, with smallest bore grip going on the left handlebar, and the larger on the throttle twist grip, if you have bought honda original parts then the twistgrip side may be a complete unit , in which case you would need to undo the 2 screws that hold the rhand switch gear together, and twist the grip in the opposit direction to what you would do when you ride it to remove it from the bendix throttle system, replace in opposite manner using a small amount of grease inside the metal sleve,
PE, UK

See if you can unscrew the handle bar first.
Then search for replacement foam online, maybe on ebay or bugaboo website.
And when you have bought the replacement foam grips, you can take a look here to see how to attach them yourself.

http://www.ehow.com/how_6730072_change-bike-grips.

html Bike grips and stroller handles work the same way.
I just used this post on e-how to replace my maclaren triumph foam handles.
Works like a charm - and it's sooo easy!! :)

sounds like its time to adjust those valves to me 0.003-0.004 on the filler gage or have done at shop.

Clamp a vice grip on to the flex plate or flywheel(from underneath thru access cover)as tight as you can,turn the bolt on the lower pulley until it (vise grip) makes contact with the block.Now place a breaker bar on the bolt and break it loose,you'll probably need an extension on the breaker bar,the bolt has loctite and will be froze solid.Good luck!

Hi,

I would suggest that you buy a replacement handle bar, which you should be able to fit yourself. Contact www.quinny.com for information.

Hope this helps.

Please visit this site and check it out on 'other motorcycles' or maybe you can go through the carburator cleaning topic and get the idea on how to go about it.
good luck.

www.xjbikes.com