Remove seat How to remove seat of the bike

try removing by upwards push or downwards push ,
find screw beneath the seats

Hi Bill:
Depending on the bike there may be minor differences, but the approach I would take would be to look around the back, lower part of the seat for some bolts holding tabs on the seat to the bike. Ob=nce you get the back undone, the seat can usually be removed by sliding it towards the rear. Patience and curiosity Bill. You'll get it!

That tube is the seat post. Without the proper clamp, you're screwed. Contact local bike shop for assistance

Hello Jerome - to remove your bike seat, locate the two bolts on either side of the seat, towards the front by the gas tank. Remove the two bolts under the seat using a ratchet & socket...Grab the seat from the front by the gas tank and lift it up until the seat is around a 45-degree angle to the frame. Then pull the seat towards the gas tank to release the rear tab that locks the seat in place at the rear by the fender... I hope this information is helpful.

While I am no expert, I have a huffy aerocruiser. I also purchase mine second hand, but the woman who sold it to me was excellent on giving instructions at pick-up time! There should have been a peice that fits over the stem of your bike seat and and arm type thing that runs from bike seat piece to the stroller itself. There should also be two clips, a wheel, and a handle. To assemble for bike use, remove your bike seat and place the bike seat adapter piece on the stem of the bike seat then replace bike seat. Use one clip to attach arm to bike seat adapter thing. Use the other clip to attach the arm to the stroller (where the front wheel would go, wheel removed). The bike seat adapter thing remains on the stem of your seat and you just remove the clip that holds the arm to the bike seat when not using the trailer.
To use for jogging, remove the arm and replace the wheel. Slide handle into place and use two clips to hold handle on.
If this requires clarification, please let me know! I may not have made it that clear. I would be happy to take some pictures if it would help!
Best of luck and enjoy your new stroller!

The battery is under the seat on the right side of the bike. You must first remove the seat by removing the screw on the top of the rear fender that holds the seat in place...you can't miss the screw, it's a big chrome philips head screw. Once the screw is removed, lift the seat up slightly and gently pull towards the rear of the bike; this will release the front of the seat from it's retaining tab. Now that the seat is off, look at the right side of the bike, the chrome box there is the battery compartment. I believe the bolts connecting the battery are 10mm...you can undo them with a wrench and pull the battery out.

I take it you have removed the rear bolt holing the rear of the rear seat to the body of the bike. The rear seat is then pulled rearwards and out of the rear hold on strap
The rear passenger hold on strap is then unbolted from the body of the bike. This will let the front seat by pulled rearward and then upwards to remove it as well.
hope this helps.

usually a 14mm wrench loosen the nut remove old seat put new seat on post tighten bolts

On an '89, remove both side covers and you will see a bolt on both sides of the bike just under the seat. Remove the bolts, lift the back of the seat and slide toward the rear of the bike.

On an '89, remove both side covers and you will see a bolt on both sides of the bike just under the seat. Remove the bolts, lift the back of the seat and slide toward the rear of the bike.