Question about 2001 Honda Accord

Open Question

How to replace clutch kit in 2001 honda accord lx manual transmission already have all i need

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
Motor-Head
  • 4 Answers

SOURCE: 1991 Honda Accord LX Cruise control doesn't work

Does your speedometer work properly? if not, check your speed sensor. Many times the connection to your speed sensor may be left disconnected especially after clutch replacement.

Posted on Jan 30, 2009

Ad
csmock132
  • 4669 Answers

SOURCE: have 1996 honda accord lx automatic wheres the

It is really short. Look under the air filter at the front of the transmission, near the bottom. It should be yellow.

Posted on Mar 24, 2009

  • 1 Answer

SOURCE: Exterior rear door handle on Honda Accord 2001

To Remove Door Panel on 2001 Honda Accord:

A: To remove the plastic piece with the door lock button and door handle connected to it:

1- Remove the screw in the middle located behind a plastic cover button
2- Push (slide) the whole assembly Forward (toward front of car)
Besides the screw, it is held in place by 3 hooks on the backside that hook into holes in the metal door frame
3- Now unhook handle from small metal bar going through door by pushing (toward door) plastic clip (blue?) off of the bar, then the bar will come out of the clip hole, thus releasing the handle.
4- Depress little grey button /bar (purple painted on it)on elec. connector to seperate connector, thus releasing door lock switch

Now the whole assembly (metal handle, door lock switch, and plastic piece) will come off door panel

B: The door is held on by 2-screws, 7-plastic snaps/plugs, and 1-plastic plug.

The screws are located: bottom of hand hold and the other behind the handle, both covered by little covers that have to be pryed off to access the screws.(hint: the screw with the built in spacer goes behind the handle when you are trying to reinstall)
The 7-plastic snaps: 3 across bottom and 2 on each side. Not visible, they are mounted to the inside of the panel.
The 1-plastic plug is visible at the upper front of the panel and is the same color as the surrounding trim


C: Take off the big plastic triangle piece above the door panel and behind the mirror. Pull/pry off. It has 2 snaps holding it on. one near bottom and one near the front.

D: Light lens prys off from bottom. Unscrew (1/4 turn) the light assembly with bulb still intact from backside of panel

E: Remove the Hand-Hold/window switch assembly:

Posted on Apr 27, 2009

Online-Tech
  • 51 Answers

SOURCE: where is the valet switch for honda accord 2002 lx?

Hi,
Does the vehicle have an aftermarket alarm system? Is the valet switch for this what you are looking for? If so, it depends entirely on who installed it as where they have put it, although it's usually under the dash on the driver’s side. Some alarms have different sequences that you have to go through to put the alarm into valet mode; it's not usually just a switch that you flick. Best to pop into an alarm or stereo installer and see if they can spot it for you, or if the car is immobilized, find out what sort of alarm it is and call an installer for the info on the valet procedure.

Thank You for contacting Fixya.com

Posted on Aug 03, 2009

  • 113 Answers

SOURCE: 1992 Honda Accord (LX) Instrument Cluster Replacement

Same as 2 dr, or a stick.
There are bezel screws that hold the plastic trim (pointing up towards the windshield), you nee to remove these 2 screws. The bottom section is clipped in. Tilt the steering wheel down as far as it will go.
Once you have the bezel off, there are 4 screws holding the cluster to the dash. Remove them and gently pull the cluster forward. Reach around (expect to get scraped knuckles) and unclip the speedo cable, and two large multipin connectors. Don't force anything.
Getting the cluster out after this point is a test of your patience. It only seems to come out one particular way.

Posted on Aug 22, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 95 honda accord lx 4cyl automatic transmission that i am rebuilding are all the steels and clutches te same size in thickness and size?


You will know when you get it apart & measure them

You will know when you buy one of several different
rebuild kits, of your choice

Get an ATRA Paper Book Manual, to use for the spec &
rebuild

Oct 01, 2014 | 1995 Honda Accord

2 Answers

I have a 2001 honda accord a manual transmission. when car is running it shifts into gears but car won't move what is the problem?


check the operation of the clutch. If it is cable operated then the cable needs replacing as it is jammed and holding the clutch pressure plate off If hydraulic then it may be the clutch master cylinder has a blockage in the compensating port which is holding the pressure plate off. Have these items checked out and if they are operational the it will be a clutch kit replacement job. Have it checked out by an accredited clutch and brake shop before you spend big money.

Jul 31, 2014 | 2001 Honda Accord

1 Answer

Honda accord in gear but wont move


clutch slip. the retaining spring in the clutch may have snapped... would need to be looked at.... or the if it is fitted with the hydraulic clutch its not letting go at the piston. would still need to be looked at eather way you need to get to the clutch to see.

Dec 05, 2013 | Honda Accord Cars & Trucks

1 Answer

2001 Honda Civic with error code P1298


is it a sick or auto? if its a auto you might just be out of fluid because of a leak or because the 1998-2002 accord automatic transmission is a failure and tend to wear out after only 90-100k miles. I got my '99's rebuilt a 98k, it was barely able to go. if its a manual, its more than likely just a simple clutch replacement.

Apr 18, 2013 | 2001 Honda Civic LX

1 Answer

Vss 1995 honda accord lx manual transmission


The speed sensor located near the drive shaft from the gearbox with a 3 wire n a 10mm bolt.. Try look somewhere where the drive shaft come out from ur gearbox

Feb 01, 2013 | 1995 Honda Accord

1 Answer

Where is the vss located on a 2001 honda accord lx, manual transmission, 4 cylinder?


It is in the transmission housing at the right rear ofthe engine compartment

Dec 20, 2010 | 2001 Honda Accord

1 Answer

1996 honda accord LX auto trans problem


yes..sir you must take your car to the nearst Honda Service Station and ask to the mechanic there to check the transmission and replace the clutch with new one. don't forget to check and maybe change all oil that have connected with your transmission. all work maybe take 1 or 2 days depend on the part that you need to change

Jan 31, 2009 | 1996 Honda Accord

1 Answer

2001 accord lx-where is transmission dipstick


You do not have a dip stick ,you have a pipe plug in the front side of trans.

Jan 01, 2009 | 2001 Honda Accord

Not finding what you are looking for?
2001 Honda Accord Logo

Related Topics:

509 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

yadayada
yadayada

Level 3 Expert

77201 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...