Cars & Trucks Logo
Posted on Aug 09, 2010

I have a 1982 landcruiser - ran fine - then changed the air pump - and now won't start unless full choked and won't idle at all - did i misplace a vacuum hose ? I can't find a vacuum hose diagram anywhere. Can you help me ?

1 Answer

Anonymous

Level 1:

An expert who has achieved level 1.

New Friend:

An expert that has 1 follower.

Problem Solver:

An expert who has answered 5 questions.

  • Contributor 6 Answers
  • Posted on Oct 05, 2010
Anonymous
Contributor
Level 1:

An expert who has achieved level 1.

New Friend:

An expert that has 1 follower.

Problem Solver:

An expert who has answered 5 questions.

Joined: Sep 29, 2010
Answers
6
Questions
1
Helped
2503
Points
8

Do you mean vacuum pump? If so you probably need to change ALL vacuum hoses. With the new pump comes new vacuum pressures, old hoses will probably be sucked off their pipe nipples or small cracks turn into large ones, one or both of the above will cause severe rough idle and running along with much power loss and fuel mileage will ****. If you have the original service manual on the truck and engine (I am assuming you have the 4.2L straight 6- 2F) it has a vacuum hose routing view in it. good luck
Rickster

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1helpful
1answer

1987 Nissan D21 with a Z24 motor: Continuous stalling at idle, runs when choked using a rag or hand, has new plugs, wires, distributor cap, rotor button, fuel pump, will not idle unless choked, i do n

need to clean the idle jet out in the carb. you need to take the carb float chamber apart and you will see 2 copper jets. unscrew one jet at a time and clean them out. screw back firm not to tight. wile open clean the filter out of the main fuel line if its black replace with new one or leave to soak in some white vinegar and brush with a old tooth brush put new seal on float chamber and put back on engine. see if its fine then it should be.
0helpful
1answer

New fuel pump and fuel lines.. Ran like a champ for day... BUT

Are you saying you think it is getting too much fuel, or not enough ?
Could be the choke or something inside the carb.
0helpful
1answer

My 2003 chryler seabring water pump went out i changed it got the car back together when i first start it in the morning it idels fine then when it warms up at stops the idle go's to 800 rpm or st

OK. Nothing to do with water pump.
Recommend checking your IAC (Idle Air Control) circuit. This allows air to bypass the throttle body while idling, at stop sign, etc.
Here are a couple of links that should help you
Chrysler Sebring Idle Air Control Valve
How To Install Replace Idle Air Control Valve 2 7L 2001 06 Chrysler...
0helpful
1answer

I have a 1982 el camino with a 3.8 V6, with a three speed. when im in park, it idles fine and it will rev up fine. but when i start to drive it down the road it will not accelerate. the motor seems to...

Sounds like a transmission problem. Change the transmission filter and fluid and make sure it is topped off to the proper level. Have the transmission checked out to ensure there isn't a problem in the torque converter.
0helpful
1answer

1995 Chevy Astro rough idle after choke goes off and engine is at full operating temperature, also no check engine light.

Inspect/replace air filter.
Fill the gas tank to above 3/4 and add Lucas FUELSYSTEM CLEANER.
Ran on the highway for 10+ miles.

Monitor is the rough idle condition is getting worst on below 1/4 tank.
Change fuel filter and check fuel pressure.
Most failing/weak fuel pump will not work well below 1/4 tank mark.
It will fail in a HOT DAY.

0helpful
1answer
0helpful
1answer

1990 full size blazer starts fine idles then dies

sounds real easy either a bad idle air control solenoid or more likley a blown throttle body gasket. to test fro a blown gasket, with engine running and cool spray carb cleaner or brake cleaner around base of tb were it bolts to intake. when it hits the bad area, should idle down and be normal for a second or 2. iac is possible,try this first since its so common and let me know
0helpful
2answers

2000 Ford Crown Victoria

when you hold the accelerator does the vehicle stay running? if so the problem is in ithe IAC idle air control motor, take a small screw driver and using the handle tap the iac motor and usualy the motor will kick in and the vehicle will run fine then if the problem is rectified replace the IAC
Not finding what you are looking for?

403 views

Ask a Question

Usually answered in minutes!

Top Toyota Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

ROBERT GARCIA
ROBERT GARCIA

Level 3 Expert

926 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...