Question about 1988 Jeep Cherokee

1 Answer

The ac. wipers signals radio ligter went off in my 1988 jeep cherokee the fuses are ok. relays too.

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    MVP:

    An expert that gotĀ 5 achievements.

    Vice President:

    An expert whose answer gotĀ voted for 100 times.

    Champion:

    An expert who has answered 200 questions.

  • Contributor
  • 245 Answers

Lets Look at the fuses once more the # 2 threw 5 i have seen the fuse be good but it had loss contact in the fuse box, remove the fuse and install them to see if this helps
Also at the battery there is a fuse link check here to see if this has blown or loss contact,, a new one can be spliced in if needs replacemint

CIRCUIT INFORMATION
(What the fuse is for.) 1 25 Amp Rear washer / wiper - Located just right of top center in fuse bank. 2 15 Amp Radio, Cigarette lighter 3 25 Amp Heater blower motor - (* - if this keeps blowing or you only have heat on one speed check your blower motor resistor pack.) 4 20 Amp Turn signal, Back-up lights, Rear window defogger relay 5 10 Amp Dome light, Courtesy lights, Glove box light, Cargo light, Radio memory, Power mirrors, Teltak connector (For old analog "bag" cell phones, I think.) 6 15 Amp Hazard warning lights, Brake / Stop lights 7 10 Amp Parking lights, Headlight Warning Chime/Buzzer, Instrument panel light dimmer 8 7.5 Amp Gauges, Instrument cluster, Seat belt warning, Headlight delay, Chime module, Overhead console 9 5 Amp Instrument panel illumination 10 25 Amp Rear window defogger 11 30 Amp
Circuit Breaker Power door locks, Power seats, Trailer towing wiring harness 12 10 Amp ETR (Delco OEM) radio, Power antenna 13
(1984 - 1987) - - - Spare Fuse (GM automatics and manual transmissions.) 13
(1988) 7.5 Amp Transmission control unit (For AW4 automatic transmissions) 14 25 Amp Headlight delay, Horns, Security alarm 15 5.5 Amp
Circuit Breaker Front windshield wipers 16 30 Amp
Circuit Breaker Power Windows 17 10 Amp Clock, Security alarm (Ignition)

Posted on Jul 15, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

1988 jeep cherokee,6 cylinder my front windsheild wipers dont work.fuse is good.the wiper motor makes a noise when its turned on.is there a relay that could be faulty?wiper switch is the same as the turn...


No relay in the circuit.
There is a delay module but if it fails that usually causes the wipers to stop in the middle of travel or only run on high.
And the switch is working if you hear noise coming from the motor. The wiper switch is not the same switch as the turn signals but it is near that assembly.
I would say if you have power to the wiper motor the motor is probably dead or something happened to the linkage to the arms.

Feb 27, 2013 | 1988 Jeep Cherokee

1 Answer

Jeep turns on but ac, turn signals, radio and horn are not working


check the fuses first then start checking the wiring for a short also for a bad gound wire

Sep 02, 2011 | 1988 Jeep Cherokee

1 Answer

94 grand cherokee fuse panel fuse id,,,need to know each fuse function, location in panel and amp


............1994 Jeep Grand Cherokee
......(Fuse Block - Passenger side of Dash)
.....1........5........9........13........17........21........25
..20 A...15 A...20 A....20 A....7.5 A.....15 A....30 A
.
.....2........6.......10.......14........18........22........26
..15 A...15 A...10 A....20 A.... 15 A.....15 A....30 A
.
.....3........7.......11.......15........19........23........27
..20 A...15 A...15 A.....3 A......15 A....15 A.....10 A
.
.....4........8.......12.......16........20........24........28
..15 A...15 A...15 A....20 A.....10 A....7.5 A....30 A
1)Trailer Tow Relay
2)Brake Lamps
3)Hazard Lamps
4)Security Lamp
5)Interior Lighting
6)Security Alarm Module
7)Security Alarm Relay, Security Alarm Module, Flash-to-Pass
8)Overhead Console, Keyless Entry, Radio Memory/Clock
Memory/Chime Module, Power Locks, Power Mirrors,
HEVAC and VIC
9)Rear Wiper
10)Radio
11)Cigar Lighter
12)Parking Lamps, Automatic Headlamps
13)Horn Relay
14)Power Lock Relays
15)ABS Module and Relay
16)Turn Signals
17)Heating and Air Conditioning Module
18)Airbag Module
19)Interior Mirror, Auto Headlamps, Overhead Console,
VIC/GDM Module, Heated Rear Window Relay Coil,
Illuminated Entry Relay and Chime Module
20)Heated Rear Window Switch, Overdrive Switch, Speed Control
21)Security Alarm Module, Lamp Outage Module
22)Airbag Module, Speedometer, Tachometer, Telltales and
Gauges
23)Heated Mirror Feed, Heated Rear Window Switch
24)Instrument Panel Illumination
25)Power Seats
26)Power Windows, Power Sunroof
27)Security Alarm Module and Front Wiper
28)Heated Rear Window Relay

Aug 19, 2010 | 1994 Jeep Grand Cherokee

1 Answer

1994 Jeep Cherokee 4.0L AC wiring


Hope you can read it? If not I'll try something else. See the compressor relay, that line with arrowhead is load side of relay, when relay is energized that arrowhead moves to other terminal, that is a fuse protected circuit, goes hot with the key on, underhood fuse box/power distribution center f6--15amp. The left side of relay is control, needs voltage and ground. fuse f5--25 amp interior fuse box and is wired through selection switch. As you can see, the computer grounds control side of relay.
Your second paragraph sounds like a big voltage drop, somewhere, I'd have make sure battery is good and charged up, check battery connections and check your charging system.
hvac 1-v5mpaghvzo1rjsiaaldzfraw-2-0.jpg

hvac 2-v5mpaghvzo1rjsiaaldzfraw-2-2.jpg

Apr 24, 2017 | 1994 Jeep Cherokee

1 Answer

88 Jeep Cherokee problems


That happen to me 3 days ago. The problem is on the ignition key. When you turn it to start the engine, once the engine starts, turn it back a little. is suppose to get back by itself but, get stuck because the cold weather.

Nov 23, 2009 | 1988 Jeep Cherokee

2 Answers

1988 cherokee wipers,radio, heater blower just went like that could it be ignition switch problem? thanks much


Yes it could be but more likely its one of the main fuses for the ignition. If the charging and oil light's come on when its switched on then the ignition switch should be ok

Sep 12, 2009 | Jeep Cherokee Cars & Trucks

1 Answer

Wipers turn signals and ac/heater not comming on


looks like they are on more than one fuse. your passenger compartment fuse box is down below your dash panel on drivers side between brake pedal and left side kick panel. the heater a/c fuse is a 25 amp fuse, should be fuse 6. the wipers are fed through a 4.8 amp circuit breaker which might be in the same fuse box, or not. your car also has a power distribution center under the hood. if you don't get anywhere with the fuses in the passenger compartment, look in the power distribution center. chrysler doesn't always share lots of info and i can only look up part of the wiring diagram. can't find anything about turn signals, my guess is that fuse is in power distribution box. hope that helps

May 31, 2009 | 1994 Jeep Cherokee Country

1 Answer

94' Jeep Cherokee Conutry 2wd Dash lights not working


try replacing the ignition switch(not the ignition lock[where the key goes]).it will probably be located on top of the steering column , towards the bottom.but before going through with this make sure the connectors to the switch are fully plugged in.

Jan 18, 2009 | 1994 Jeep Cherokee Country

1 Answer

1994 Jeep Cherokee Sport Fuse Needed?


Sometimes there are relays under the hood. There is usually a diagram posted underneath the door when you tak it off. The turn signal is usually just a fuse, which may be in your glove box(has a diagram under the door), under the driver or passenger side dash. Do you still have the manual for the vehicle?

Nov 08, 2008 | 1998 Jeep Cherokee

Not finding what you are looking for?
Cars & Trucks Logo

462 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8140 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...