Where is the clutch slave cylnder resivior located on a 1989 audi 80

check dupper clutch master for leakage ,if no leakage then check d lower slave cylinder for leakage ,if dry then replace ur clutch plate and cover. also check ur gear oil if it is manual.

sounds like a clutch slave cylnder or clutch master cylnder or possible air in system. try bleeding system first!

this is due to air in the clutch system, or a low fluid level. bleed some new clutch fluid through. It may be caused by a leaking seal, so check for leaks at the clutch master cylnder and slave cylnder. the master cylnder seal sometimes leaks down the firewall inside the car. Replacement cylnders ar an easier option than replacing just the seals

Either your clutch master cylnder or the slave cylnder have gone bad. with out them working you will not be able to do anything with the car.


Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/sean_54c3a3dc48a7773c

You have to bleed the slave.

The bleeder valve will be on the slave cylinder. Follow the hydraulic line from the Master Clutch cylinder down to the slave cylinder by the transmission.

If you mean the clutch slave cylinder, it is under the dash attached directly to the pedal cluster.. the slave cylinder is located on top of the transmission, accessed from underneath the left front area behind the wheel...

loading up to much fuel check front o2 sensor

hi, depending on the model, you may have a mechanical clutch. if there's a clutch master and slave cylinder under the hood, its hydraulic. the main issue here is that your pressure plate. you will need to replace this. this will fix the issue.

slave cyl is sepreate from master cyl you have air in the clutch hydraulic system replace slave and inspect clutch master for leaks on drivers floor board area pull carpet back and make sure to bleed system properly!!!!!!!