SOURCE: Dual Temperature controls inside - 2002 lincoln ls
The problem is most likely a bad dual climate control valve. This component is located on the right side near the radiator under the hood. It will have several coolant hoses hooked to it and 2 silver cylinders protruding from it. You can clamp off the heater hoses at the heater core and see if both sides cool then and this will tell you that the valve is letting coolant thru when it shouldn't be.
This will narrow it down to either the valve or the control head inside the car,or wiring in between them. The only way to narrow it down further is if you have a scan tool that could access the climate control data. Have seen several of these valves cause this concern and have only seen one control head cause it.
SOURCE: 2004 Chevy Silverado AC is blowing warm air on passenger side.
You have dual zones that are controlled by temperature actuators the passenger side has lost its memory or has gone bad you can put it in self programming by disconnecting the battery for ten minutes then hook it back up start the truck turn the temperature control on but do not touch any other controls let it go thru the self programming for about 6 to 7 minutes then select your temperature you want if it still does not work properly you may have a bad actuator or a bad connection at the actuator
SOURCE: 2004 chevrolet suburban AC blows hot/cold at same time
You need to replace the drivers side temp actuator that is located on the left side of the HVAC box. It is retained by 3 screws and is fairly easy to replace.
SOURCE: a/c blows hot air on drivers sde
The actuator door on the driver's side is out of position and needs to be reset. Remove the negative battery cable for 1/2 hour to reset the computer. Start the HVAC system and you should be able to hear the door adjusting itself and cold should come out of the driver's side vent.
SOURCE: Air/C, blows hot air on drivers and cold air on passenger side?
The vent actuator my need to be reset, this can be done by removing the HVAC fuse from the fuse panel for 5 min or disconnecting the battery. If the vent actuator does not correct it self, then it's most like going to have to be replace due to internal parts have broke in the actuator.
Thank you for using fixya and it's common for the vent actuators to go bad after a few years, the internal parts are made of plastic and get brittle after time.
NO HEAT ON FLOOR VENTS
---------
As
per your problem mentioned. There are few solved help links to
troubleshoot these problems. Go through the list and Click the link below:----
http://whatisbyme.blogspot.in/2012/05/2000-toyota-avalon-no-heat-on-passenger.html
------------
------------
http://schematicsdiagram.blogspot.in/2012/02/heater-blows-cold.html
-----------
http://repairhelpcenter.blogspot.com/2012/01/hot-air-on-drivers-side-vents-only.html
--------------
-----------
http://technoanswers.blogspot.in/2012/04/1992-toyota-camry-ac-control-light.html
--------------
http://technoanswers.blogspot.in/2012/02/no-heatblower-blows-only-cold.html
----------
-------------
http://whoisbyme.blogspot.in/2012/06/2009-mercury-grand-marquis-ac-blows.html
-----------
http://schematicsdiagram.blogspot.in/2012/04/ac-not-blowing-through-vents-on-2007.html
----------
http://schematicsdiagram.blogspot.in/2012/04/passenger-side-temperature-is-warm-air.html
----------
These
will help.
Thanks.
As
per your problem mentioned. There are few solved help links to
troubleshoot these problems. Go through the list and Click the link below:----
------------
------------
http://schematicsdiagram.blogspot.in/2012/02/heater-blows-cold.html
-----------
http://repairhelpcenter.blogspot.com/2012/01/hot-air-on-drivers-side-vents-only.html
--------------
-----------
http://technoanswers.blogspot.in/2012/04/1992-toyota-camry-ac-control-light.html
--------------
These will help.
Thanks.
1,053 views
Usually answered in minutes!
×