Inlinefuse 2003 town and country where is the fuse located? How do I change the fuse?

Gary Queen

• 85 Answers
• Posted on Aug 24, 2008

SOURCE: changing fuel filter on 2004 chrysler town and country

1. Remove or disconnect the following:
   • Negative battery cable
2. Raise the vehicle and support the fuel tank with a transmission jack.
   • Fuel line from the front of the tank
   • Ground strap
   • Inboard side of the fuel tank straps and front T strap fastener and lower the tank about 6 inches
   • Fuel lines from the fuel pump module
   • Fuel filter
3. Installation is the reverse of removal. Tighten the fuel filter bolts to 40 inch lbs. (4.5 Nm), the main tank straps to 40 ft. lbs. (54 Nm) and the T strap to 250 inch lbs. (28 Nm).
4. Start the engine and check for leaks.

SOURCE: fuse box chrysler town and country van

2002 town and country uses a relay and fuse...check fuse # 10 (a 40amp) in the box under the hood. the relay is also there

SOURCE: fuse for stereo/cd in chrysler town and country minivan

Its in the box next to the battery and i had the same problem.The fuse is on the first line top.

Thanks

SOURCE: locassion of output speed sensor on 2003 Town and Country

The input and output speed sensors look identical on the connector side. The one over the solenoid pack is the input, the one closer to the left frame rail or left front wheel is the output sensor. I hope this helps.

SOURCE: How do I change the fuse for my radio and where is

you will find the fuse box locations in your owners manual in the glove box,it will show you what each fuse feeds