How to fix or disable passenger seat belt chime? It sometimes goes off for no reason.

Question moved from MISC
'year make model' as first three words in every question please.

There is a sensor in the bottom of the fixed clip and a connection under the seat for the belt chime and is the most likely cause of both.

Does the seat belt like flash and the chime go off if there is only a passenger strapped into the car?

Actually take a flashlight look into the receiver side of the seat belt see if you can see any change inside of it sometimes that happens good luck

Lequita, put your seat belt on or take things off your passenger seat. Sounds like your seat belt chime is telling you someone needs to buckle up.

YOU CAN' DISABLE THE ALARM.IS PART OF SRS SYSTEM.BUY FROM YOU LOCAL DEALER BELT BUKAL ONLY AND REPLACE.IS EASY AND LOW COST.

Check all your seat belt attachments! This seem to be a leading oroblem with all vehicles that has a few miles on them. All it takes is wasting coffie or soda's into one of those locking mechanisms and it thinks the seat belt is not locked. All these vehicles have seat sensors too! If you sat anything more than 3 to 5 lbs on the seat, it thinks someone is sitting on the seat and the chime will continually go off and drive you nuts. Hope this helps you with your problem Sir

Hi Candy, I'm glad to help!

Candy, I'm not sure why you want to disable the pass seat belt chime, maybe its going off even with no one in the seat. BUT, the only way to stop it would be to plug the seat belt into the buckle. Hope this helps and have an awesome day Candy

To enable or disable the seat belt warning chime on your 2005 Jaguar Type S

1. Ensure the front passenger seat is unoccupied.

NOTE:

Steps two to five must be completed within 60 seconds.

2. Turn the ignition to the RUN position (do not start the engine).

3. Buckle the driver safety belt buckle and wait until the seat belt warning lamp extinguishes.

4. Unbuckle the driver safety belt buckle and wait until the seat belt warning lamp illuminates.

5. Repeat Steps three and four a further eight times.

6. When the driver safety belt buckle is unbuckled for the ninth time a single chime will be heard. The single chime is acknowledgement that the beltminder feature has been disabled.

The beltminder feature will be disabled until the above process (Steps one to six) are repeated. Upon repeating the process the beltminder feature will be reactivated

Unfortunately if you take this to a shop they can get into alot of trouble doing this for you. Some are controlled by the body control module and others are just simple circuits. Look at you seat belt female end and look for a harness that goes to it. If it's just 2 wires connect those two wires together to trick the system! You should always wear your seatbelt by the way.

Q: Are you wearing your seat belt? Yes? No?

A: No.
Solution: Put on your seat belt!!!!!! Save a life!!!

A: Yes.
Soultion: There has to be a fuse either under the dash or under the hood that controlls the chime.
There is a switch in the seatbelt connecter that controlls the chime. It has either failed or the wireing that carried the signal to shut the chime off has been damaged.

HI.
ON Ford cars and Suv's,
Some times the sound chime after the seat belt buklet.
Is like a open door.
The problem on this car is that the the DOOR AJAR SWITCH. come danaged. and the Body cumputer don't recievethe door close signal.
But is intermitent.
The door ajar switch is on the door lacth.
You only can get front the dealer.
OK. I hope this information can be useful for you.

Thank you.