20 Most Recent
1997 Mercury Sable Questions & Answers
Grinding and scrapping noise
I'm assuming you are using the correct stock wheels for this vehicle. You will need to check the tracking/alignment on the steering to check it is all lined up correctly. The outer tie rod can be used to adjust the front wheel alignment and if fitted in the wrong position can cause the rim or tyre to rub when at full steering lock.
SAFELY jack up the front of the vehicle and rest the vehicle on jack stands. Spin each wheel and listen for the noise you heard. You may need a helper to turn the steering as you do this. Remove a wheel and take a good look at the inner rim edge and inner face of the wheel rim. Look for scratches and other scrape marks. Do this on both sides. Refit the wheel and get your helper to turn the steering from lock to lock, the scratches should line up with what is causing the sound.
Car stalled while driving. went to start it and
Sounds to me like the main engine fuse has popped
Usually a 30amp fuse
If fuse is ok then check the connection to the battery cable as well as the ground wires to engine and chassis
Problem will be there
How to change rear brakes on a 1997 mercury sable
Replace caliper with old brake pads put 1 bolt in place to hold together while taking a large screwdriver and prying caliper piston so that it compresses piston & block wedge to rear of bracket it should make enough room to install on new brake pads, the other way is to use a large c clamp put 1/4 pice of wood in between c clamp and caliper so you don't damage or Mar the caliper also check YouTube.
1997 mercury sable
Have someone check your brake calipers for sticking and holding the brakes applied. This can cause overheating and they will try to stop the wheel, causing the violent steering wheel shake. Also have them check the constant velocity(CV) joints, which if bad can make steering stiff.
How do you tell if a brain box is out on a 97 mucury sable
brain box is out ?????? What problem are you having , what's not working ? Normally hooking up a scan tool to see if it will communicate . Checking for DTC'S - diagnostic trouble codes Etc.... Checking power and ground circuits to the PCM / ECM powertrain control module or electronic control module . Not brain box . If you are unfamiliar with this , do yourself a favor and take it to a qualified repair shop .
Not finding what you are looking for?