How to remove headlight switch on 2004 chrysler town and country

Gary Queen

• 85 Answers
• Posted on Aug 24, 2008

SOURCE: changing fuel filter on 2004 chrysler town and country

1. Remove or disconnect the following:
   • Negative battery cable
2. Raise the vehicle and support the fuel tank with a transmission jack.
   • Fuel line from the front of the tank
   • Ground strap
   • Inboard side of the fuel tank straps and front T strap fastener and lower the tank about 6 inches
   • Fuel lines from the fuel pump module
   • Fuel filter
3. Installation is the reverse of removal. Tighten the fuel filter bolts to 40 inch lbs. (4.5 Nm), the main tank straps to 40 ft. lbs. (54 Nm) and the T strap to 250 inch lbs. (28 Nm).
4. Start the engine and check for leaks.

SOURCE: 2007 Chrysler TOWN AND COUNTRY.. OVRHEAD MAP

I had the same problem on my 07 and it turned out to be caused by the bulbs getting too hot and melting the surrounding plastic which opened the circuit powering them. I was able to fix the problem by removing the bulbs and cleaning the sockets allowing the bulbs to seat correctly. The lenses snap off to give you access to the bulbs. If you are not familiar with how interiors of cars come apart, I would not suggest doing it as you may crack the lens.

SOURCE: how to replace our low beam headlight on 1999 town and country

1.) Open the hood of your van 2.) On the passenger side of the vehicle, look behind the headlight enclosure. You will see a set of wires running into the back of it. This is the power clip. Either with your hand or a flat-head screwdriver, pop the power clip off.
3.) There is a plastic ring encasing the light bulb. Turn the ring counter-clockwise and pull it out of the socket and set it aside.
4.) Pull firmly on the light bulb to remove it.
5.) Place the new light bulb into the same opening. Be careful not to touch the glass part of the new bulb. The oils in your skin can substantially reduce the life of the new bulb.
6.) Replace the plastic ring and turn it clockwise to lock it in place.
7.) Reattach the power clip to the back of the bulb.

SOURCE: chrysler town and country wiring diagram

Where is the amplifier located on a 2002 Town & Country? My stereo seems to be working, but there is no sound coming out of the speakers.

SOURCE: How do you remove the front blower motor for a

Follow your vehicle's service manual procedures for blower motor removal. The following are general removal procedures:

• Disconnect the negative battery cable.
• Disconnect the blower motor lead connector from the wiring harness connector.
• Remove the blower motor cooling tube from the blower motor.
• Remove the four retaining screws.
• Turn the motor and the wheel assembly slightly to the right so that the bottom edge of the mounting plate follows the contour of the wheel well splash panel.
• Lift up on the blower and remove it from the blower housing.
• Installation the new blower motor by reversing the removal steps.
• Connect the negative battery cable.