Where is auto trans overdrive solenoid? there is a bank of them but can't find diagram to know which to replace. It's the one that controls shifting into overdrive.

1995 ford explorer 4WD 6cyl- where is auto trans overdrive solenoid? there is a bank of them but can't find diagram to know which to replace. It's the one that controls shifting into overdrive.

5 Related Answers

ricky horwood

128 Answers
Posted on Dec 27, 2008

SOURCE: won't shift into overdrive

these cars are a 4 speed auto
it you here the car change 4 times then it is going in to od
best way to try this is by following

go to an open rood where you can do 100kph (60mhp)
have your overdrive turned off (there should be a light on the dash board that comes on)
then turn over drive on and see if the RPM drops

if it dose not work let me know and i will try my best to help you
ricko

Anonymous

42 Answers
Posted on Feb 13, 2009

SOURCE: 1999 ram auto trans wont shift into park

you could need a throttle linkage adjustment. first check to see if your ram will start in "park" and "neutral" only. if it starts in any other gear=faulty neutral safety switch. replace. ok, now check linkage for proper adjustment...with engine off and in park...remove intake housing..disconnect cableend from attatchment stud on your throttle body..slide cable off the stud (carefully)..verify that the transmissionthrottle lever is fully forward (idle) position..and verify that the lever on the throttle body is at curb idle pos..insert small screwdriver under edge of the retaining clip and remove..center the cable end on attatchment stud to within 0.04", or 1mm. install retaining clip onto cable housing..check cable adjustment..be sure trans throttle lever and throttlr body lever move in sync with each other.

Harvey N Tawatao

3854 Answers
Posted on Apr 05, 2009

SOURCE: I have a 1995 GMC Jimmy with auto trans., it wont

Your going to have to get the Jimmy scaned before youhurt the transmission, It sounds like it's on a Limp mode which can range from a tune up to a bad ground. Good luck.

Testimonial: "Thanks for the info. I ended up sell the jimmy and passed on the info to the buyer they also found it helpful."

Anonymous

122 Answers
Posted on Sep 11, 2009

SOURCE: I have a 2002 Honda Accord with Auto Trans. I

i would check the transaxle fluid first, if it is fine, I would then take it and change the fluid and filter. if this does not correct it, quite possibly the transaxle is faulty, sorry, I hope that the fluid corrects it for you, thanks

Anonymous

819 Answers
Posted on Nov 11, 2009

SOURCE: auto trans having problems with the overdrive

get it to your local trans shop for a diagnostic, sounds like rebuild time.

Add Your Answer

Upload

Upload an image from your computer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

Loading...

Include an image. It's worth a thousand words.

prev next

Related Questions:

0helpful

1answer

Sorry question came out wrong don't know why. I have a 1993 ranger 4.0 auto. When you try to take off on overdrive whont go, if you put in drive shifts fine then you shift into overdrive works OK. You...

If it seems to still be in overdrive when you come to a stop, the brake light switch has an electric cut out switch incorporated in it to shut off power to the trans/overdrive to kick it out of OD. If this switch is malfunctioning, it can cause this problem your having.

Read full answer

Nov 27, 2017 • Cars & Trucks

0helpful

2answers

2004 Ford Sportrac having problems with trans OD flashing on and off and sticking in gear?

When the Torque Converter Clutch (TCC) isn't engaging or locks in engagement the light flashes a warning...The TCC solenoid may stick due to dirty transmission fluid...If the Check Engine Light
(CEL) is not lit have your transmission fluid changed...If it is lit the code is probably pointing at a defective TCC, Computer (PCM) or the clutch itself... you can take the vehicle to an auto parts store and have them read and define the trouble code for free...saailer

I’m happy to help further over the phone at https://www.6ya.com/expert/david_6df67de3b14de867

Read full answer

Feb 19, 2015 • 2004 Ford Explorer Sport Trac

0helpful

1answer

I have to error code with my jeep grand Cherokee Laredo 1999 the code are 1491,1495,753,136

P1491 Rad Fan Control Relay Circuit An open or shorted condition detected in the radiator fan control relay control circuit. This includes PWM solid state relays.P1495 Leak Detection Pump Solenoid Circuit An open or shorted condition detected in the Leak Detection Pump (LDP) solenoid circuit.P0753 (M) Trans 3-4 Shift Sol/Trans Relay Circuits An open or shorted condition detected in the overdrive solenoid control circuit or Trans Relay Circuit in JTEC RE transmissions. Was MIL code 45. P0753 (M) Trans 3-4 Shift Sol/Trans Relay Circuits An open or shorted condition detected in the transmission 2-4 shift solenoid circuit (4-speed auto. trans. only).P0136 (M) 1/2 O2 Sensor Heater Circuit Malfunction Oxygen sensor heater element malfunction.

Aside from getting into an accident and having your wiring harness severely damaged, the other likely suspect is your PCM. These codes are not related to each other and indicate a much larger problem.

Read full answer

Nov 02, 2013 • 1999 Jeep Grand Cherokee

1helpful

1answer

I have a 89 Isuzu, GMC diesel, NPR. Previous owner put in a new, rebuilt Jatco trans now it has no overdrive. ?, Jatco auto trans. Won'y shift into overdrive . trans

possible shift solinoid failure (overdrive shift solinoid)

Read full answer

Jun 25, 2012 • Cars & Trucks

0helpful

1answer

Where is the overdrive solenoid located on my 2001 Buick park avenue? I have the transmission pan off , can i put that back on and still put the solenoid? i would like a diagram of where it is located

You will need to pull off the side pan cover thats where the overdrive solenoid is located, lets see if i can get you a diagram to help you loacte it.i will tell you that there are two shift solenoid to control the gears and overdrive, there have been problems with jerking in overdrive this is due to the tcc solenoid and wiring harness and also the computer must be reflashed, dealer has update shifting and thats a must, i would replace that as far as the overdrive solenoid here are diagrams. the computer uses the shift solenoid with the pressure solenoid to control the overdrive i have circled the solenoid to replace , as theres not just one to control overdrive i have listed the one that control it .hope this helps.

Read full answer

Sep 24, 2011 • 2001 Buick Park Avenue

0helpful

2answers

93 Mitsubishi 3000gt overdrive problem

I think rebuild try and service it if you find any lining material in the pan bad news

Read full answer

Jun 06, 2010 • 1993 Mitsubishi 3000GT

0helpful

1answer

Auto trans lost 3rd and overdrive . 2nd trans in 2 months. both had under 100,000 miles on them. filter and fluid was changed after install. the fluid is still red and does not smell burnt.

the solenoids for the shift control seem to be the problem. Check the computer for codes. Auto Zone will do a computer scan for free if you take your car there and ask for this free scan

Read full answer

Mar 24, 2010 • 1996 Dodge Intrepid

0helpful

1answer

1997 ford taurus 3.0 ltr trans wont shift into overdrive. first thrugh third gears shift fine but it doesnt try to shift into overdrive at all. the trans shows no signs of slipping and the fluid looks...

Solenoid pack in trans. Position module,is just that. Wrong guess. What tran model do you have? You also have other sensors to consider but have to know the trans your working on and the computer and shift stratagy involved to solve this,even if your throwing parts at it.

Read full answer

Feb 06, 2010 • 1997 Ford Taurus

1helpful

1answer

1991 toyota p/u auto trans wont shift to overdrive

The trans in your truck had some problems in that era with overdrive. You will need ot check a few things to be sure it is not internal. The overdrive would often fail in those units due to the o rings used instead of lip seals.

Check the temp sensor. If it is bad the trans will not go into od. A defective solenoid in the trans for overdrive could cause it not to go in.

Check the fluid, if it is black, you may have burnt the clutches. I have know people who have driven the toyo's for years with no od. It is the same as the old three speed auto.

Hope this helps

Read full answer

Nov 19, 2009 • 1991 Toyota Pickup

1helpful

1answer

No overdrive

this is a hard mechanical fault in the overdrive forward clutch, u must overhaul the trans to fix this.

Read full answer

Jun 18, 2009 • 2000 Mitsubishi Galant

Not finding what you are looking for?

View Most Popular

Cars & Trucks

Sorry question came out wrong don't know why. I have a 1993 ranger 4.0 auto. When you try to take off on overdrive whont go, if you put in drive shifts fine then you shift into overdrive works OK. You...

Cars & Trucks

869 views

Ask a Question

Usually answered in minutes!

Related Topics:

Where is auto trans overdrive solenoid? there is a bank of them but can't find diagram to know which to replace. It's the one that controls shifting into overdrive.