What is name of part used to remove lug nuts
SOURCE: Tire Change on 2006 Ford Explorer
Kick the tire. Not only will it make him feel better, but it should come off. The center of the wheel is probably a tight fit where it fits on the 'hub' (where the brakes and wheel bearings are located. Kick the tire near the outer edge, continue all around 'til it comes off. Please let me know how you make out. countrycurt0
SOURCE: tire stuck/lug nuts removed
use 3lb sledge on inner edge of rim be careful not to damage rim rubber mallet won't provide enough shock to loosen rust. ps leave one lug nut on so tire won't fly off.
SOURCE: how do I change the tire on a 1999 chevrolet silverado 1500 4wd
the plastic nut doesnt actually come all the way off. it just stays with the center. and once you get these undone you can then pull the cover off
SOURCE: Can not remove lug nut caps 2003 x -type jaguar
I have an 04 xj8. the lug nuts are a good bad example of half baked engineering. the lug nuts are fabricated from ugly steel with an 11/16 hex end. to beautify this, Jaguar overlays the nut end with a stainless steel 3/4 inch cap, crimped to the nut. On top of this, the nut is to be torqued to 90+ ft-lb! The only way to remove the lug nut without damage is with a SIX POINT socket and a breaker bar or an impact wrench. Using a 12 point socket will deform the cap, causing the wrench to spin on the cap and or the cap to spin on the nut itself. If that has happened, it is possible to recover using a 15 oz or thereabouts ball peen hammer and a deep 3/4 inch impact socket (the black ones). Line up the socket to the cap, doing a best guess to where the flats are and give the socket a light blow. Keep trying that until the socket seems to stick on, then hit it harder. Eventually you will find the right point and the socket will go on and reform the cap. Then a breaker bar can remove the cap/nut. New assemblies can be had for about $6 from "partsbin" or "autohausaz".
SOURCE: Can not remove rear tires after removing lug nuts, wheels are jamed onto hub.
spray pentrating oil around where wheel meets hub and also around lug bolts let set for about 15 min then take a sledge hammer and hit from underneath make sure the truck is blocked up good for safty
if that doesnt work take a small sissor jack between the rim and the fram and put a lot of pressure on it then hit it with the sledge from underneath
136 views
Usually answered in minutes!
×