Security light flashing 2011 toyta rav4

Steve Allison

• 5569 Answers
• Posted on Aug 23, 2008

SOURCE: A4 steering lock does not engage and car won't turn over

The steering locks don't necessarily engage when the key is removed, I always turn the wheel before exiting to engage it. There are several positions that will allow the pin to lock in but if between these, it may seem that it isn't locked.

SOURCE: Immobiliser light flashing and car

Hello, do you know what the locksmith did to get the code on your key? Did anything else flash on the screen when the car would not start. My car is doing the same thing, and my Jaguar dealer is 200 miles away. My screen is showing [Engine Fault, Transmission Fault and DSC Fault]. Any help would be greatly appreciated..

SOURCE: security system not working as it used to

i read this on the subaru tech bulletin page
i had the same problem - apparently i had inadvertently put the system into "valet" mode
to get back to normal, unlock with remote - open drivers door - hold down the unlock button on your remote for 2-3 sec - the flashing light will go out and your system should be back to normal
it's too bad the manual doesn't supply information about activating and deactivating "valet" mode
good luck

SOURCE: 2000 Alero Security light flashing and wont start

With the new lock cylinder in it, turn the key on. The security light should blink. Leave the key on for 10 minutes, the security light will quit blinking and go out after 10 min. This will reprogram your security system and the car should start. Also leave a battery charger on it while the key is on, If the battery goes dead during the 10 minute reprogram sequence, you will have to start over again.

SOURCE: 93 bonneville security light flashing

your key reader is not reading the chip in your key you can either replace the ignition switch cost about 250 dollars parts and labor or i can tell you how to bypass it for less than 20 bucks in premium chat hope this helps
thanks wes