My temperature, fuel, speed gauges are not working.

If the tail lights, low fuel light, temperature gauge, and fuel gauge are not working, there could be several possible causes:

1. Blown Fuses: Check the fuses for the tail lights, low fuel light, temperature gauge, and fuel gauge. If any of these fuses are blown, replace them with a new one.
2. Loose or damaged wiring: Inspect the wiring for the tail lights, low fuel light, temperature gauge, and fuel gauge. Look for any loose connections or damaged wires. Repair or replace any damaged wires and ensure all connections are tight.
3. Faulty sending units: The low fuel light and fuel gauge are connected to the fuel sending unit in the gas tank. The temperature gauge is connected to a temperature sending unit on the engine. Check these sending units for faults, and replace them if necessary.
4. Faulty instrument cluster: The instrument cluster itself could be faulty, causing the temperature and fuel gauges to not work. A qualified mechanic can test the instrument cluster to see if this is the issue.

It's also possible that the trike has a separate electrical system for the tail lights, and that this system is malfunctioning. A qualified mechanic can test the trike's electrical system to determine the cause of the issue.

Well ronnie do you know how to do automotive electrical testing with a volt meter ? How to read an understand a wiring diagram ? Would think not to be a relay problem because other thing's would not work as well ! More then likely a loose ground or something on that order ! Plus you must mean Ignition . 1 relay , because there isn't a eng.1 relay . Ign. 1 relay powers the PCM - engine computer , fuel injectors , the TAC - electronic throttle control module . Do the instrument cluster lights still work when the gauges quit ? Looking at power distribution diagram I see a engine 1 fuse but has nothing to do with the instrument cluster . Supply's B+ voltage to the maf sensor , EVAP system , CAM sensor , IAT sensor , fuel pump relay ! Could be a communication problem on class 2 data bus . All the modules on the vehicle share information on the class 2 bus . The gauges get thier info from the PCM over this data network !
Engine Coolant Temperature Gauge
The IPC displays the engine coolant temperature as determined by the PCM. The IPC receives a class 2 message from the PCM indicating the engine coolant temperature. The engine coolant temperature gauge defaults to 75°C (160°F) or below when:
• The PCM detects a malfunction in the engine coolant temperature sensor circuit.
• The IPC detects a loss of class 2 communication with the PCM.

Fuel Gauge
The IPC displays the fuel level as determined by the PCM. The IPC receives a class 2 message from the PCM indicating the fuel level percent. The fuel gauge defaults to empty if:
• The PCM detects a malfunction in the fuel level sensor circuit.
• The IPC detects a loss of class 2 communications with the PCM.
When the fuel level is less than a pre-determined value, the low fuel indicator illuminates.
Reviewing the fuel system description will further explain how the system functions. Refer to:

Speedometer
The IPC displays the vehicle speed based on the vehicle speed signal from the PCM. The IPC receives the vehicle speed signal via a discreet wire. The IPC uses the vehicle speed signal circuit (4000 pulses/mile) from the PCM in order to calculate the vehicle speed. The speedometer defaults to 0 km/h (0 mph) if a malfunction in the vehicle speed signal circuit (4000 pulses/mile) exists.

Tachometer
The IPC displays the engine speed based on the engine speed signal from the PCM. The IPC receives the engine speed signal from the PCM via a discreet wire. The IPC uses the engine speed signal circuit (2 pulses/engine revolution) from the PCM in order to calculate the engine speed. The tachometer defaults to 0 rpm if a malfunction in the engine speed signal circuit (2 pulses/engine revolution) exists.
Transmission Temperature Gauge
The IPC displays the transmission temperature as determined by the PCM. The IPC receives a class 2 message from the PCM indicating the transmission temperature. The transmission temperature gauge will default to 40°C (100°F) or below if:
• The PCM detects a malfunction in the transmission temperature sensor circuit.
• The IPC detects a loss of class 2 communications with the PCM.
Voltmeter
The IPC displays the system voltage as detected at the ignition 1 input of the IPC. When the engine is ON, the gauge should be between 10 and 16 volts.

The only one that has a hard wired sensor is the oil pressure gauge.
Engine Oil Pressure Gauge
The IPC uses the engine oil sensor signal to determine the engine oil pressure. The oil pressure sensor signal circuit is hard-wired to the IPC. The engine oil pressure sensor signal to the IPC is a variable resistance ranging from 0-90 ohms. A sensor resistance of 1 ohms will display as 0 psi (0 kPa) and a resistance of 88 ohms will display as 80 psi (550 kPa). The Check Engine Oil Pressure indicator will be displayed in the message center if the IPC detects a low engine oil pressure.

Does this one drop out also ? quit working

I would suggest that you take an have the IPC checked for DTC'S - diagnostic trouble codes , NOT OBD 2 engine codes , these are different an need a professional type scan tool .
You could check G103 for being loose . G103
On the left rear of the engine block . Also pull the instrument cluster out an check connection at the back of IPC . Check power an ground circuits at the PCM as well . You can fine wiring diagrams here
http://www.bbbind.com/free_tsb.html Enter the vehicle info . year , make , model an engine . under system click body an acc. then under subsystem click on instrumentation .Click the search button , then click the blue link . At the top of the diagram it shows B+ power supply , The connectors on the back of IPC , A,B , plus the pin # an color wire .
PCM power and ground testing avi
How To Use Multimeter Test Car Ground Video 3
Intermittent Electrical Diagnostics with Rich Peterson

When you have a check engine light, there are codes stored. That's where you start--with the codes

If all voltages checked ok,then most probably its faulty instrument cluster board on which gauges are connected.Yes if cluster circuit board looks ok,then also it can be faulty.Somewhere there is minute short or burn on board then such prolem arises.
Also check the fuse box.One under hood and other under dash.Inspect each and every fuse and see if all are fine or not.
---------------For more troubleshooting on these cluster gauges i suggest you to refer the list of help links mentioned below.Its step by step instructions will help you to confirm the exact cause of problem in these conditions:---------
Click the link below:------

2004 Toyota Tundra: Oil Gauge and Temp Gauge Not Working?

http://howtobyme.blogspot.in/2012/05/2004-toyota-tundra-oil-gauge-and-temp.html

--------------

2005 Lexus SC430: Fuel Door, Dome light and Fuel Gauge Fuse Location?

http://howtobyme.blogspot.in/2012/05/2005-lexus-sc430-fuel-door-will-not.html
----------

Toyota 4Runner: Temperature Gauge Sensor

http://technoanswers.blogspot.in/2012/04/toyota-4runner-temperature-gauge-sensor.html
------------

Temperature gauge sits over half way mark?

http://schematicsdiagram.blogspot.in/2012/04/temperature-gauge-sits-over-half-way.html

---------------

Heater blows intermittently and temp gauge goes erratic?

http://technoanswers.blogspot.com/2012/01/heater-blows-intermittently-and-temp.html

----------

Temperature gauge does not move and no heat when heater is ON?

http://technoanswers.blogspot.com/2012/01/temperature-gauge-does-not-move-and-no.html

-----------

2003 Pontiac Grand Prix: Erratic Fuel Gauge?

http://technoanswers.blogspot.in/2012/06/2003-pontiac-grand-prix-erratic-fuel.html

-----------

Temperature gauge keeps fluctuating up and down close to red?

http://technoanswers.blogspot.com/2012/01/temperature-gauge-keeps-fluctuating-up.html

-------------

Temperature gauge on the dash quit working on Pontiac Grand Prix?

http://technoanswers.blogspot.com/2012/01/temperature-gauge-on-dash-quit-working.html

---------------

Fuel gauge jumps from empty to full?

http://schematicsdiagram.blogspot.com/2011/12/fuel-gauge-jumps-from-empty-to-full.html

--------------

Gas gauge stuck on empty on 2002 Mercedes Benz 240c?

http://repairhelpcenter.blogspot.in/2012/02/gas-gauge-stuck-on-empty-on-2002.html
---------------

• Oldsmobile Temperature Gauge Lamp Switch?

-----------------

Fuel gauge drops to Empty?

http://technoanswers.blogspot.com/2012/01/fuel-gauge-drops-to-empty.html

----------------

Dodge neon gauges not working?

http://technoanswers.blogspot.in/2012/02/dodge-neon-gauges-not-working.html

------------

Temperature gauge went up?

http://schematicsdiagram.blogspot.com/2011/12/temperature-gauge-went-up.html

------------

Temperature gauge stays At cold on jaguar?

http://technoanswers.blogspot.in/2012/02/temperature-gauge-stays-at-cold-on.html
-----------

How to replace Instrument panel and dashboard on Toyota car?

http://repairhelpcenter.blogspot.in/2012/02/how-to-replace-instrument-panel-and.html

-----------

How to remove instrument panel on Chevrolet car?

http://technoanswers.blogspot.in/2012/02/how-to-remove-instrument-panel-on.html

-----------

How to remove control panel on Buick regal?

http://howtobyme.blogspot.in/2012/02/how-to-remove-control-panel-on-buick.html
---------------
These details will help.Thanks.

If all voltages checked ok, then most probably its faulty instrument cluster board on which gauges are connected. Yes if cluster circuit board looks ok, then also it can be faulty. Somewhere there is minute short or burn on board then such problem arises.

Also check the fuse box. One under hood and other under dash.

Inspect each and every fuse and see if all are fine or not.

---------------

For more troubleshooting on these cluster gauges I suggest you to refer the list of help links mentioned below. Its step by step instructions will help you to confirm the exact cause of problem in these conditions: ---------

Click the link below: ------

2004 Toyota Tundra: Oil Gauge and Temp Gauge Not Working?

http://howtobyme.blogspot.in/2012/05/2004-toyota-tundra-oil-gauge-and-temp.html

--------------

2005 Lexus SC430: Fuel Door, Dome light and Fuel Gauge Fuse Location?

http://howtobyme.blogspot.in/2012/05/2005-lexus-sc430-fuel-door-will-not.html

----------

Toyota 4Runner: Temperature Gauge Sensor

http://technoanswers.blogspot.in/2012/04/toyota-4runner-temperature-gauge-sensor.html

------------

Temperature gauge sits over half way mark?

http://schematicsdiagram.blogspot.in/2012/04/temperature-gauge-sits-over-half-way.html

---------------

Heater blows intermittently and temp gauge goes erratic?

http://technoanswers.blogspot.com/2012/01/heater-blows-intermittently-and-temp.html

----------

Temperature gauge does not move and no heat when heater is ON?

http://technoanswers.blogspot.com/2012/01/temperature-gauge-does-not-move-and-no.html

-----------

2003 Pontiac Grand Prix: Erratic Fuel Gauge?

http://technoanswers.blogspot.in/2012/06/2003-pontiac-grand-prix-erratic-fuel.html

-----------

Temperature gauge keeps fluctuating up and down close to red?

http://technoanswers.blogspot.com/2012/01/temperature-gauge-keeps-fluctuating-up.html

-------------

Temperature gauge on the dash quit working on Pontiac Grand Prix?

http://technoanswers.blogspot.com/2012/01/temperature-gauge-on-dash-quit-working.html

---------------

Fuel gauge jumps from empty to full?

http://schematicsdiagram.blogspot.com/2011/12/fuel-gauge-jumps-from-empty-to-full.html

--------------

Gas gauge stuck on empty on 2002 Mercedes Benz 240c?

http://repairhelpcenter.blogspot.in/2012/02/gas-gauge-stuck-on-empty-on-2002.html

---------------

• Oldsmobile Temperature Gauge Lamp Switch?

-----------------

Fuel gauge drops to Empty?

http://technoanswers.blogspot.com/2012/01/fuel-gauge-drops-to-empty.html

----------------

Dodge neon gauges not working?

http://technoanswers.blogspot.in/2012/02/dodge-neon-gauges-not-working.html

------------

Temperature gauge went up?

http://schematicsdiagram.blogspot.com/2011/12/temperature-gauge-went-up.html

------------

Temperature gauge stays At cold on jaguar?

http://technoanswers.blogspot.in/2012/02/temperature-gauge-stays-at-cold-on.html

-----------

How to replace Instrument panel and dashboard on Toyota car?

http://repairhelpcenter.blogspot.in/2012/02/how-to-replace-instrument-panel-and.html

-----------

How to remove instrument panel on Chevrolet car?

http://technoanswers.blogspot.in/2012/02/how-to-remove-instrument-panel-on.html

-----------

How to remove control panel on Buick regal?

http://howtobyme.blogspot.in/2012/02/how-to-remove-control-panel-on-buick.html

---------------

These details will help.

Thanks.

I would be looking for a ground problem.
http://www.mustangandfords.com/how-to/interior-electrical/75259-instrument-electricity
This article will help you understand what to look for.

have a Bora 1.9 TDI on 02 plate the fuel, temp not work, also airbag light is on all the time , we have check all the fuses on the side panel and the look ok, the lights and indicator are workign fine

You have blown a fuse..check fuse box. There may be one fuse box one in the cabin but also check for the fusebox in the engine compartment.

Seems like a dodgy earth behind dash panel. Hope this helps..

Some cars have a second fuse box under the hood near the battery. See if your car doesn't have one of those.