Is it hard to replace the starter on a 2001 Nissan Maxima?

Phil Lovisek

• 726 Answers
• Posted on Jul 19, 2008

SOURCE: starter 2000 maxima se

Firts disconnect battery. Remoce air filter box. You will see the starter right under neith the air box. You will see a rubber bute. Under the boot is a 12mm wrench size nut. Remove nut. There is a single wire connector. Unplug connector. There are 2 bolts holding the starter to the trans. One of them is pretty big.(19mm socket size ?) and the other is smaller. Remove them both and the starter will come out. Reverse install procedure. Good luck

SOURCE: location of a o2 sensor 2001 nissan maxima

bank 1 refers to the side of the engine that #1 cylinder is on , and sensor 2 refers to downstream , after the catalytic converter. , this link shows bank 1 on a 2001 nissan maxima V6 being on the firewall side . if you had a 4 cylinder it would be downstream after the catalytic converter .

http://www.autozone.com/N,26200242/shopping/specsSelect.htm

SOURCE: how to replace belts on 2001 nissan maxima

which belt?

SOURCE: 2001 nissan maxima gle crank no start code p1320...please help

Primary ignition fault. Reasons: Bad distributor cap (most likely) or ignition control module/ignition coil.
Hope that helps
Good Luck

Greg Bernett

• 2993 Answers
• Posted on Jun 30, 2009

SOURCE: locate and replace starter for 2002 nissan maxima

Starter location and mounting detail — with manual transaxle


Remove or disconnect the following:

• Negative battery cable from the battery
• Air duct
• Harness protector from the harness
• Starter wiring at the starter
• Starter-to-engine bolts
• Starter from the vehicle