Anonymous posted an answer for this 2005 Isuzu Ascender:
"Unfortunately Isuzu does not offer a repair manual for the 05 Ascender. I believe that the..."
Anonymous posted an answer for this 2005 Isuzu Ascender:
"Assuming that it is 2 wheel drive 6 cyl then it has struts on the front and shocks on the..."
Anonymous posted an answer for this 2004 Isuzu Ascender:
"Is there a repair manual for a 2004 Isuzu Ascender?"
Anonymous posted an answer for this 2004 Isuzu Ascender:
"No, there is not one available. However, the Chevy Trailblazer is basically the same..."
Anonymous posted an answer for this 2004 Isuzu Ascender:
"Sometimes cuts off after starting could it be the battery"
Anonymous posted an answer for this 2004 Isuzu Ascender:
"It shouldnt be the battery. The battery power is used to start the vehicle. If it cuts off..."
Anonymous posted an answer for this 2003 Ford Expedition:
"it is probably a wheel speed sensor. thats what was wrong with my explorer"
Anonymous posted an answer for this 2003 Ford Expedition:
"The abs light stays on on my 2003 Ford Explorer xlt"
Anonymous posted an answer for this 1999 Ford Explorer:
"what size is the oil drain plug on a 2000 ford explorer xls"
Anonymous posted an answer for this 1999 Ford Explorer:
"the oil drain plug uses a 13mm wrench or socket to take it out."
Anonymous posted an answer for this 1999 Ford Explorer:
"no it doesnt, overdrive is the normal driving position for the best fuel economy."
Anonymous posted an answer for this 1999 Ford Explorer:
"Does driving in over drive harm vehicle?"
Anonymous posted an answer for this 1999 Ford Explorer:
"Every time you try to step on the gas hard it clunks and sputters then the engine light..."
Anonymous posted an answer for this 1999 Ford Explorer:
"it could be a vacuum leak or a fuel issue if the check engine light has come on then a..."
Anonymous posted an answer for this 1999 Ford Explorer:
"the fluid may be low or the power steering pump may be going out."
Anonymous posted an answer for this 1999 Ford Explorer:
"99 ford explorersport: winding noise in power steering at idle. Steering is ok how can I..."
Anonymous posted an answer for this 1999 Ford Explorer:
"you might need to have the radiator system flushed out. or it might be low on water"
Anonymous posted an answer for this 1999 Ford Explorer:
"its over heating some times ? and its not the thermostat"
Anonymous posted an answer for this 1999 Ford Explorer:
"Everything works great but when you accelerate it just dies right out.Let off the gas and..."
Anonymous posted an answer for this 1999 Ford Explorer:
"You have a vacuum leak either under the dash that works the air conditioner or under the..."
Anonymous posted an answer for this 2004 Ford F150:
"the maf sensor (mass airflow) is located under the hood, it is installed in the air intake..."
Anonymous posted an answer for this 2004 Ford F150:
"Where is map sensor for 1994 ford explorer 4.0?"
Anonymous posted an answer for this 1997 Ford Explorer AWD:
"there is avacuum line that makes that door open and close. the vacuum line may not be..."
Anonymous posted an answer for this 1997 Ford Explorer AWD:
"a/c door willnot let cold air threw the vents a/c is charge"
Anonymous posted an answer for this 1996 GMC Sonoma:
"Its not good to disconnect the battery to reset the check engine light. when you do this..."
Anonymous posted an answer for this 1996 GMC Sonoma:
"RESETTING CHECK ENGINE LIGHT"
Anonymous posted an answer for this 2002 Ford Explorer:
"i have a ford explorer sport 2002 and my chek engine light came on it put out a code PO401..."
Anonymous posted an answer for this 2002 Ford Explorer:
"PO401 code means that: The PCM has determined that there is insufficient flow in the..."
Anonymous posted an answer for this 2003 Jeep Liberty:
"i have code P0320 and P0340 on my jeep liberty what does this mean"
Anonymous posted an answer for this 2003 Jeep Liberty:
"P0320 Ignition Engine Speed Input Circuit malfunction P0340 Camshaft Position Sensor..."
Anonymous posted an answer for this 1997 Mercury Mountaineer:
"try unhooking the negative side of the battery, wait a couple minutes and then hook it..."